Data Sheet Rev. 1.07 / August 2010 ZSC31150 Fast Automotive Sensor Signal Conditioner ZSC31150 Fast Automotive Sensor Signal Conditioner Brief Description Benefits The ZSC31150 is a CMOS integrated circuit for No external trimming components required highly-accurate amplification and sensor-specific Only a few external protection devices needed correction of bridge sensor signals. Digital PC-controlled configuration and One-Shot TM TM compensation of sensor offset, sensitivity, calibration via IC or ZACwire interface: temperature drift, and non-linearity is Simple, cost efficient, quick, and precise accomplished via an internal 16-bit RISC TM TM End-of-Line calibration via IC or ZACwire microcontroller running a correction algorithm, with interface calibration coefficients stored in an EEPROM. High accuracy (0.25% FSO -25 to 85C The ZSC31150 is adjustable to nearly all bridge 0.5% FSO -40 to 125C) sensor types. Measured values are provided at the The ZSC31150 is optimized for automotive TM analog voltage output or at the digital ZACwire environments by its special protection circuitry TM and IC interface. The digital interface can be and excellent electromagnetic compatibility used for a simple PC-controlled calibration procedure, in order to program a set of calibration coefficients into an on-chip EEPROM. Thus, a Available Support specific sensor and a ZSC31150 are mated Evaluation Kits digitally: fast, precise, and without the cost Application Notes overhead associated with trimming by external Mass calibration setup devices or a laser. Physical Characteristics Features Supply voltage 4.5 to 5.5 V Digital compensation of sensor offset, sensitivity, temperature drift, and non-linearity Operation temperature: -40C to 125C (-40C to +150C derated, depending on Adjustable to nearly all bridge sensor types, product version) analog gain of 420, overall gain up to 2000 Available in SSOP14 or as die Output options: ratiometric analog voltage output (5 - 95% in maximum, 12.4 bit TM resolution) or ZACwire (digital one-wire- interface) ZSC31150 Application Circuit Temperature compensation: internal or external diode, bridge resistance, thermistor VCC Sensor biasing by voltage or constant current Sample rate up to 7.8 kHz Sensor High voltage protection up to 33 V Module OUT Supply current: max. 5.5mA ZSC Reverse polarity and short circuit protection 31150 Wide operation temperature up to -40+150C Traceability by user-defined EEPROM entries Several safety and diagnostic functions GND 2010 Zentrum Mikroelektronik Dresden AG Rev. 1.07 All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without the prior written consent of the copyright owner. The information furnished in this publication is subject to changes without notice.