BD5-G3-AH Applied Motion

Accessories Power Supplies BLDC Applied Motion offers the following DC power supplies for use with the brushless DC drives and motors. PS50A24: 50 Watts at 24 VDC, recommended for BL030-H03-G motor. Motors & Drives PS150A24: 150 Watts at 24 VDC, recommended for BL060-H03-G motor. PS320A48: 320 Watts at 48 VDC, recommended for BL105-H03-G motor. RC-050 Regeneration Clamp The RC-050 regeneration clamp is for use where regeneration from the motor may be excessive for the power supply. In these cases the RC-050 is connected between the drive and power supply and absorbs regenerated energy. Extension Cable For applications where motors and drives are separated by more than 30cm (1 foot) High performance, low cost, brushless speed control systems 30 to 105 watts continuous shaft output Operates from 12 to 48V DC power supply Driver can supply up to 6.25A continuous, 12.5A peak Excellent speed stability Eight digital inputs for commanding a variety of functions Two digital outputs for interfacing to other equipment 383838 85%k Two on board potentiometers plus 12 bit analog input for setting speed, ac- celeration, deceleration 404 Westridge Dr. DistributeD b:y 76%C Watsonville, CA 95076 68%M 006BB3 Tel: 800-525-1609 67%Y For more information visit: www.applied-motion.com/BLDC Fax: 831-761-6544 90%K www.applied-motion.com 10/15/2012 925-0013 A 8 FFFFFF When over a dark color...BD5 Dimensions BD5 Drive 30 High performance, low cost speed control drive Operates from 12 to 48V DC power supply Output current: up to 6.25Arms continuous, 12.5A peak Eight digital inputs for com- manding a variety of functions Two digital outputs for inter- facing to other equipment 65 Two on board potentiometers plus 12 bit analog input for setting speed, acceleration, deceleration 100 For more information go to www.applied-motion.com/BLDC s IO Connections 17 18 SPEEDSEL2 INCOM 15 16 SPEEDSEL1 ANA GND 13 14 SPEEDSEL0 ANA IN 11 12 STOP 5V 9 10 SPEEDSET SPDOUT- 7 8 ENABLE SPDOUT+ 5 6 STOPMODE FAULT- 3 4 DIR FAULT+ 1 2 5V GND 2 3 DIGITAL INPUTS DIGITAL ANALOG OUTPUTS INPUT