EVAL-3CH4CHSOICEBZ Analog Devices

EVAL-3CH4CHSOICEBZ User Guide UG-935 One Technology Way P.O. Box 9106 Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 Fax: 781.461.3113 www.analog.com Using the EVAL-3CH4CHSOICEBZ iCoupler Data Isolator Evaluation Board FEATURES EVALUATION BOARD PHOTOGRAPH Access to all 4 data channels Enable/disable controls Multiple connection options Support for active probes Provision for cable terminations Support for printed circuit board (PCB) edge mounted coaxial connectors Easy configuration Sample iCoupler digital isolator must be ordered separately SUPPORTED iCoupler GENERICS ADuM130D/ADuM130E/ADuM131D/ADuM131E ADuM140D/ADuM140E/ADuM141D/ADuM141E/ADuM142D/ ADuM142E ADuM230D/ADuM230E/ADuM231D/ADuM231E ADuM240D/ADuM240E/ADuM241D/ADuM241E/ADuM242D/ ADuM242E Figure 1. GENERAL DESCRIPTION The EVAL-3CH4CHSOICEBZ evaluation board supports triple- The board follows PCB design practices for 4-layer boards, and quad-channel standard data isolators in 16-lead SOIC including a full power and ground plane on each side of the packages. The evaluation board provides a JEDEC standard isolation barrier. No other electromagnetic interference (EMI) 16-lead SOIC N and SOIC W pad layout and routing appropriate or noise mitigation design features are included on the board. In for the evaluation of supported devices. The evaluation board cases of very high speed operation or when ultralow emissions provides a connection to power supplies by screw terminals and are required, refer to the AN-1109 application note for additional includes optimal bypass capacitors. Signal channel routing supports board layout techniques. signal distribution and loopback, and provides positions for Full specifications for the device under test (DUT) are available in loads referenced to the VDD1/VDD2 and GND1/GND2 planes. the corresponding product data sheet, which should be consulted Signal sources can be conducted to the board through header in conjunction with this user guide when using the evaluation pins or edge mounted SMA connectors SMA connectors must be board. ordered separately. Positions for through hole 0.2 inch headers compatible with active probes are provided on the PCB probe header pins must be ordered separately. PLEASE SEE THE LAST PAGE FOR AN IMPORTANT WARNING AND LEGAL TERMS AND CONDITIONS. Rev. A Page 1 of 9 14276-001UG-935 EVAL-3CH4CHSOICEBZ User Guide TABLE OF CONTENTS Features .............................................................................................. 1 Power Input ....................................................................................3 Supported iCoupler Generics ......................................................... 1 Data Input/Output Structures .....................................................3 Evaluation Board Photograph ......................................................... 1 Bypass on the PCB ........................................................................4 General Description ......................................................................... 1 High Voltage Capability ...............................................................4 Revision History ............................................................................... 2 Evaluation Board Schematics and Artwork ...................................5 Evaluation Board Circuitry ............................................................. 3 Ordering Information .......................................................................9 PCB Evaluation Functions .......................................................... 3 Bill of Materials ..............................................................................9 Connectors .................................................................................... 3 REVISION HISTORY 12/2016Rev. 0 to Rev. A Deleted Figure 2 Renumbered Sequentially ................................. 4 Changes to Supported iCoupler Generics Section ....................... 1 Changes to Bypass on the PCB Section .......................................... 4 Moved Figure 1 ................................................................................. 1 Change to Figure 5 ............................................................................ 5 Changes to Figure 1 .......................................................................... 1 Changes to PCB Evaluation Functions Section, Connectors 5/2016Revision 0: Initial Version Section, and Data Input/Output Structures Section .................... 3 Rev. A Page 2 of 9