Click here for production status of specific part numbers. Evaluates: MAX25410 MAX25410 Evaluation Kit General Description Features and Benefits The MAX25410 evaluation kit (EV kit) demonstrates USB Type-C CC1/CC2 Protection Switches Maxims automotive USB-PD port protector with inte- Integrated 550m V FETs with 250mA CONN grated V switch, host charger adapter emulation, CONN Overcurrent Protection system-level ESD, short-to-V protection, and short- BUS USB 2.0 D+/D- Protection Switches with 1GHz to-battery protection. Bandwidth The EV kit is designed to be plugged into any USB 2.0 24V CC and USB 2.0 Protection against Type-C port, effectively providing a new fully protected Short-to-V BUS Type-C port. The EV kit only requires one external power- Automatic Fault Detection and Recovery with supply source to operate. Protection is always main- tained, whether or not the input supply is present. Industry-Compliant Reset Timings The MAX25410 can be used to protect any USB 2.0 inter- Integrated BC1.2, Apple and Samsung Charge Emulation face and USB-PD controller, but also provides a Type-C compliant 1W V switch to power E-marked cables. Supports BC1.2 CDP and DCP Modes CONN Simply connect the V enable input pins to a USB- Apple 2.4A, 1.0A CONN PD controller to evaluate MAX25410 in a given system. Samsung 2.0A Additionally, MAX25410 automatic fault recovery enables China YD/T 1591-2009 Charging Specification a seamless user experience. Compatible with USB On-the-Go Specification and Apple CarPlay The MAX25410 also features integrated host-charger port-detection circuitry that adheres to the USB-IF BC1.2 High ESD Protection (HVD+/HVD-, HVCC1/HVCC2) battery-charging specification, Apple iPod/iPhone/iPad 2kV Human Body Model and Samsung 2.0A, and Chinese Telecommunication 15kV ISO 10605 Air Gap Industry Standard YD/T 1591-2009 charge emulation. 8kV ISO 10605 Contact The EV kit is populated with a MAX25410AGTE/V+ (vari- 15kV IEC 61000-4-2 Air Gap ant with active-low V enable, auto-CDP and auto- CONN 8kV IEC 61000-4-2 Contact DCP/Apple 2.4A host-charger emulation modes). Other Proven PCB Layout variants can be used by simply replacing the IC on the EV kit. Box Content MAX25410 EV Kit Fully Assembled and Tested Ordering Information appears at end of data sheet. Apple, iPod, iPhone, and iPad are registered trademarks of Apple Inc. Samsung is a registered trademark of Samsung Electronics Co., Ltd. 319-100490 Rev 1 1/20Evaluates: MAX25410 MAX25410 Evaluation Kit Getting Started Figure 1. EV Kit Interfaces Table 1. Jumper List JUMPER FUNCTION CONTROL J4 Charge Mode Selection Low: auto-CDP High: auto-DCP/Apple 2.4A See V switch-enable table. J5 V EN1 Control CONN CONN Manual Control: Set jumper to H or L J6 V EN2 Control CONN Automatic Control: Connect enable input to USB-PD Controller Note: This table applies to the default IC installed on the EV kit: MAX25410AGTE/V+. To evaluate V active- CONN high and/or USB data pass-through mode, replace U1 with the required IC. Please refer to the Ordering Table in the MAX25410 data sheet. Maxim Integrated 2 www.maximintegrated.com