MAX77958EVKIT-3S6# Analog Devices

Click here to ask about the production status of specific part numbers. Evaluates: MAX77958, MAX77961 MAX77958 Evaluation Kit with 2S/3S Li+ 6A Buck-Boost Charger OUT General Description Features The MAX77958 evaluation kit (EV kit) is a fully assembled High Voltage V Range BUS and tested printed circuit board (PCB) that demonstrates Short to V Protection on CC Pins BUS the MAX77958 Standalone USB Type-C and Power Type-C Support and USB-PD Support Delivery Controller. Mode configuration: DFP/UFP/DRP The EV kit enables easy evaluation of the following Type-C rev1.3 and PD3.0 Compatible features: Cable Orientation and Power Role Detection USB Type-C Detection/PD Communication Integrated V Switch with OCP (See Table 1 for Acronyms) CONN Power Role (Sink and Source), Data Role Support Try.Snk State (UFP and DFP) detection Support Audio PD Adapter Detection and PD Communication Support Debug Accessory Sink/Source Mode Integrated V Switch with OCP CONN Power/Data Role Swap FRS (Fast Role Swap) Initial Sink Support PPS (with PD Adapter Supporting PPS) PPS (Programmable Power Supply) Sink Support Audio and Debug Accessory Sink/Source Mode Support BC1.2 Legacy/Proprietary Charger Detection Vendor Defined Message Integrated D+/D- Switches BC1.2 Legacy Charger Detection: SDP, CDP, DCP MTP Memory for Storing Custom Configuration and DCD Timeout 2 Moisture Detection and Corrosion Prevention I C Master to Control Companion IC Customization Script Nine Configurable GPIOs (GPIO6 for SID) 2 I C Programmable Configuration The EV kit contains a MAX77961 charger to demonstrate 2 2 the I C master feature of the MAX77958. The MAX77961 I C Master to Control External Charger or DC-DC is a buck-boost charger for 2S/3S Li+ battery applica- Converter IC tion and is capable of 3.5V to 25V input voltage, with Nine Configurable GPIOs (GPIO6 for SID) a maximum programmable fast charging current of 6A. External SuperSpeed Mux/Detection/IRQ The MAX77961 can be configured as the 2-cell or 3-cell EN/DISABLE External Power or FETs application by the CONG pin resistor (R5), refer to the 2 MAX77961 data sheet for more details. On-Board I C Interface The MAX16904 (a buck converter) is installed on the EV Windows 10 Compatible kit to provide 5V to V pin. The MAX77958 uses CONN Proven PCB Layout GPIO2 to enable the buck converter when the MAX77958 Fully Assembled and Tested is in SOURCE Power Role. A Micro-B USB cable is included in the package to serve as the interface from a USB port on a Windows PC to 2 the slave I C port on the MAX77958. A Windows based Ordering Information appears at end of data sheet. software provides a user-friendly interface to exercise the features of the MAX77958. Windows is a registered trademark and registered service mark of Microsoft Corporation. 319-100671 Rev 0 1/21Evaluates: MAX77958, MAX77961 MAX77958 Evaluation Kit with 2S/3S Li+ 6A Buck-Boost Charger OUT Figure 1. MAX77958 EV Kit-2S6/3S6 Maxim Integrated 2 www.maximintegrated.com