Evaluates: MAX86160 MAX86160 Evaluation Kit General Description Quick Start The MAX86160 evaluation kit (MAX86160EVSYS ) provides MAX86160 EV Kit (MAX86160 Breakout EV kit, a proven design to evaluate the MAX86160 integrated IFC6410, 5V/3A power adapter and micro-USB cable heart-rate monitor sensor module. The EV kit consist of included) two boards. IFC6410 is the main board and MAX86160 Windows PC Breakout EV kit is the daughter board that includes the Procedure MAX86160. The EV kit is powered using an external 5V/3A power supply to the IFC6410, and +1.8V through The EV kit is fully assembled and tested. Follow the steps an LDO for the sensor and +5.0V for the internal LEDs of below to verify board operation: the MAX86160. 1) Visit www.maximintegrated.com/evkit-software to The EV kit comes with a MAX86160EFN+ installed in an download the most recent version of the EV kit software, 18-pin OLGA package. SetupPPG EvKit max86160 x.x.zip. Save the EV kit software to a temporary folder and uncompress the ZIP Features file. Real-Time Monitoring 2) Open SetupPPG EvKit max86160 x.x.msi and follow Data-Logging Capabilities the instructions from the pop-up windows as shown in Figure 1, Figure 2, and Figure 3. Fully Assembled and Tested 3) Connect the MAX86160 Breakout EV Kit (J4 and J5) Windows 7, and Windows 8/8.1-Compatible to IFC6410 main board (P1 and P3), as shown in Software Figure 4. 4) Power up the boards by connecting the 5V/3A power supply adapter to the IFC6410 (J4) and wall socket. 5) Connect the micro-USB cable from the PC to the EV kit board through J3. Ordering Information appears at end of data sheet. 6) Install the ADB drivers for IFC6410. Drivers can be found in the installed folder of Maxim SensorStudio, .. Maxim Integrated SensorStudio5 USB drivers 7) Open SensorStudio5 and verify that the EV kit is connected by observing the status bar at the lower- left corner of the GUI, as shown in Figure 5. If Disconnected is shown, please double-check the boards power supply, USB connection, and press Refresh to try. 8) From the top menu, choose View and then click on PPG EvKit. The MAX86160 PPG evaluation page will then appear, as shown in Figure 6. 9) Pressing the Start Monitoring button with the AGC box checked will start the PPG evaluation. LED current will automatically be adjusted by the driver. 10) Place the test subject on top of the MAX86160 (U1) of Windows is a registered trademark and registered service mark the MAX86160 Breakout EV Kit and observe the PPG of Microsoft Corporation. graphs. See Figure 7. 19-8602 Rev 0 8/16MAX86160 Evaluation Kit Evaluates: MAX86160 Figure 1. Setup SensorStudio Software Step 1 Maxim Integrated 2 www.maximintegrated.com