100200-4X50-2 Anaren

Model 100200-4X50-2 Chip Termination 30 Watts, 50 General Specifications Resistive Element Thick film Substrate Beryllium oxide ceramic Terminals Thick film silver Electrical Specifications Resistance Range: 50 ohms, 2% Frequency Range DC 3.0 GHz Features: Power: 30 Watts DC 3.0 GHz VSWR 1.25:1 DC 3.0 GHz Note: Tolerance is 0.010, unless otherwise specified. Designed to meet of 30 Watts exceed applicable portions of MIL-E-5400. Operating temperature is -55C to 150C (see chart for derating temperatures). BeO Ceramic All dimensions in inches. Specifications subject to change with out notice. Non-Nichrome Resistive Element Low VSWR 100% Tested Outline Drawing 100200-4X50-2 (097) Rev B USA/Canada: (315) 432-8909 Available on Tape and Reel For Pick and Toll Free: (800) 544-2414 Place Manufacturing. +44 2392-232392 Europe: Model 100200-4X50-2 Typical Performance: Power De-rating: Mounting Footprint and Procedure: .025 MIN. (2 PLACES) .025 MIN. (2 PLACES) BOARD LOWER BOARD EVEN BOARD LOWER BOARD HIGHER THAN LEAD. WITH LEAD. THAN LEAD. THAN LEAD. BOARD LOWER BOARD EVEN BOARD LOWER BOARD HIGHER SUGGESTED STRESS RELIEF METHODS NOT RECOMMENDED APPLICATION THAN LEAD. WITH LEAD. THAN LEAD. THAN LEAD. SCALE: NONE SCALE: NONE SUGGESTED STRESS RELIEF METHODS NOT RECOMMENDED APPLICATION SCALE: NONE SCALE: NONE SUGGESTED MOUNTING PROCEDURES: SUGGESTED MOUNTING PROCEDURES: MAKE SURE THAT THE DEVICES ARE MOUNTED ON 1. MAKE SURE THAT THE DEVICES ARE MOUNTED ON 1. FLAT SURFACES (.001 UNDER THE DEVICE) TO FLAT SURFACES (.001 UNDER THE DEVICE) TO OPTIMIZE THE HEAT TRANSFER. OPTIMIZE THE HEAT TRANSFER. 2. DRILL & TAP THE HEATSINK FOR THE APPROPRIATE 2. DRILL & TAP THE HEATSINK FOR THE APPROPRIATE THREAD SIZE TO BTHREAD SIZE TO BE E USEUSED.D. 3. COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH 3. COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH QUALITY SILICONE GREASE (.001 MAX. THICKNESS). QUALITY SILICONE GREASE (.001 MAX. THICKNESS). 4. POSITION DEVICE ON MOUNTING SURFACE & SECURE 4. POSITION DEVICE ON MOUNTING SURFACE & SECURE USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER. USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER. TORQUE SCREWS TO THE APPROPRIATE VALUE. MAKE SURE TORQUE SCRETHAT THE WS TO THE APPRODEVICE IS FLAT AGAINST THEPRIATE VA HEALUETSI. MANK.KE (CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF SURE THAT THE DEVICE IS FLAT AGAINST THE HEATSINK. THE LEADS TOWARDS THE LID). (CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF 5. SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH THE LEADS TOWARDS THE LID). A CONTROLLED TEMPERATURE IRON. 5. SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH A CONTROLLED TEMPERATURE IRON. ** FOR MORE DETAILS CONTACT FACTORY ** ** FOR MORE DETAILS CONTACT FACTORY ** 100200-4X50-2 (097) Rev B USA/Canada: (315) 432-8909 Available on Tape and Reel For Pick and Place Toll Free: (800) 544-2414 Manufacturing. Europe: +44 2392-232392