RoHS Recast Compliant SATA-Disk Module 5 SDM5 7P/180D Low Profile Product Specifications April 15, 2015 Version 1.5 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 Fax: +886-2-2267-2261 www.apacer.com SATA-Disk Module 5 APSDMxxxxX3AX-ATXX Features: Standard Serial ATA 3.1 Revision Temperature ranges SATA 6.0 Gbps interface Operating: ATA-8 command set Standard: 0C to 70C Backward compatible with SATA 1.5/3.0 Extended: -40C to 85C Gbps Storage: -40C to 100C Capacities Supply voltage Standard Type: 1, 2, 4, 8, 16 GB 5.0 V 5% High-speed Type: 8, 16, 32 GB Power consumption (typical)* (available in cable-less type only) Standard Type: Performance* Active mode: 130 mA Burst read/write: 600 MB/sec Idle mode: 95 mA Standard Type: High-speed Type: Sustained read: up to 42 MB/sec Active mode: 275 mA Sustained write: up to 41 MB/sec Idle mode: 85 mA High-speed Type: Connector type Sustained read: up to 290 MB/sec 7-pin SATA signal connector Sustained write: up to 265 MB/sec Form factor Flash Management SATA Disk Module: 7-pin/180 degree Built-in hardware ECC, enabling up to Dimensions (without housing): 40-bit correction per 1K bytes 30.00x27.80x8.20, unit: mm** Static/dynamic wear-leveling 30.00x27.80x7.40, unit: mm*** Flash bad-block management Dimensions (with housing): S.M.A.R.T. 32.50x29.40x8.53, unit: mm Power Failure Management ATA Secure Erase Shock & Vibration**** TRIM Shock:1500 G Vibration: 15 G NAND Flash Type: SLC MTBF: >2,000,000 hours RoHS Recast compliant Complies with 2011/65/EU standard *Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations or platform settings. The term idle refers to the standby state of the device. **Standard type ***High-speed type ****Non-operating 1 2015 Apacer Technology Inc. Rev. 1.5