RoHS Recast Compliant SATA-Disk Module 5A-M SDM5A-M 7P/180D Low Profile Product Specifications (Toshiba 15nm) February 25, 2016 Version 1.2 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 Fax: +886-2-2267-2261 www.apacer.com SATA-Disk Module 5A APSDMxxxGX2AN-CTM1XX Features: Standard Serial ATA 3.1 Revision Temperature Range SATA 6.0 Gbps interface Operating: ATA-8 command set Standard: 0C to 70C Backward compatible with SATA 1.5/3.0 Extended: -40C to 85C Gbps Storage: -40C to 100C Capacity Supply Voltage Standard type: 4, 8, 16, 32 GB 5.0 V 5% High-Speed type: 32, 64 GB (cable-less Power Consumption* type only) Standard Type: Performance* Active mode: 160 mA Burst read/write: 600 MB/sec Idle mode: 80 mA Standard Type: High-Speed Type: Sustained read: up to 125 MB/sec Active mode: 225 mA Sustained write: up to 40 MB/sec Idle mode: 70 mA High-Speed Type: Connector Type Sustained read: up to 435 MB/sec 7-pin SATA signal connector Sustained write: up to 80 MB/sec Power segment options: 2 metal pins on Flash Management each side of SATA connector or power Built-in hardware ECC cable connector Static/dynamic wear-leveling Form Factor Flash bad-block management SATA Disk Module: 7-pin/180 degree S.M.A.R.T. Dimensions (without housing): Power failure management ATA secure erase 30.00x27.80x8.20, unit: ** TRIM 30.00x27.80x7.40, unit: *** NAND Flash Type: MLC Dimensions (with housing): 32.50x29.40x8.53, unit: MTBF: >1,000,000 hours Shock & Vibration**** Shock:1,500 G Vibration: 15 G RoHS Recast Compliant Complies with 2011/65/EU standard *Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations or platform settings. The term idle refers to the standby state of the device. **Standard type ***High-speed type ****Non-operating 1 2016 Apacer Technology Inc. Rev. 1.2