RoHS Recast Compliant SATA-Disk Module 5A-M SDM5A-M 22P/90D Product Specifications (Toshiba 15nm) January 2, 2018 Version 1.4 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 Fax: +886-2-2267-2261 www.apacer.com Features: Standard Serial ATA Revision 3.1 Temperature Range SATA 6.0 Gbps interface Operating: ATA-8 command set Standard: 0C to 70C Backward compatible with SATA 1.5/3.0 Extended: -40C to 85C Gbps Storage: -40C to 100C ATA/ATAPI commands supported Supply Voltage Capacity 5.0 V 5% 8, 16, 32, 64 GB Power Consumption* Performance* Active mode: 205 mA Burst read/write: 600 MB/sec Idle mode: 80 mA Sequential read: Up to 245 MB/sec Connector Type Sequential write: Up to 75 MB/sec 7-pin SATA signal connector Flash Management 15-pin SATA power connector Built-in hardware ECC Form Factor Global Wear Leveling SATA Disk Module: 22-pin/90 degree Flash bad-block management Dimensions: 44.00 x 30.00 x 9.95, unit: mm S.M.A.R.T. Power Failure Management Shock & Vibration** ATA Secure Erase Shock:1,500 G TRIM Vibration: 15 G NAND Flash Type: MLC RoHS Recast Compliant MTBF: >1,000,000 hours Complies with 2011/65/EU Standard *Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations or platform settings. The term idle refers to the standby state of the device. **Non-operating 1 2018 Apacer Technology Inc.