RoHS Recast Compliant SATA-Disk Module 5A-M SDM5A-M 7P/180D Low Profile 2 Product Specifications (Toshiba 15nm) November 8, 2017 Version 1.2 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 Fax: +886-2-2267-2261 www.apacer.com Features: Standard Serial ATA 3.1 Revision Temperature Range SATA 6.0 Gbps interface Operating: ATA-8 command set Standard: 0C to 70C Backward compatible with SATA 1.5/3.0 Extended: -40C to 85C Gbps Storage: -40C to 100C Capacity Supply Voltage 16, 32, 64GB 5.0 V 5% Performance* Power Consumption* Burst read/write: 600 MB/sec Active mode: 225 mA Sequential read: Up to 425 MB/sec Idle mode: 70 mA Sequential write: Up to 80 MB/sec Connector Type Flash Management 7-pin SATA signal connector Built-in hardware ECC Power segment options: 2 metal pins on Global Wear Leveling each side of SATA connector or power cable connector Flash bad-block management Flash Translation Layer: Page Mapping Form Factor S.M.A.R.T. SATA Disk Module: 7-pin/180 degree Power Failure Management Dimensions (without housing): 33.00 x 29.30 x 8.85 ATA Secure Erase Dimensions (with housing): TRIM 35.20 x 30.40 x 9.25 NAND Flash Type: MLC Shock & Vibration** MTBF: >1,000,000 hours Shock:1,500 G Endurance (in Terabytes Written: TBW) Vibration: 15 G 16 GB: 22 TBW Write Protect Switch (optional) 32 GB: 39 TBW RoHS Recast Compliant 64 GB: 48 TBW Complies with 2011/65/EU Standard *Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations or platform settings. The term idle refers to the standby state of the device. **Non-operating 1 2017 Apacer Technology Inc.