13000X778 series High performance pushbutton switches threaded bushing 11.9 mm momentary DISTINCTIVE FEATURES Fully sealed, black Double shell case for high mechanical strength and electrical insulation CECC approved (CECC 96401-001) Highly reliable contacts Compact size ELECTRICAL SPECIFICATIONS Max. current/voltage rating with resistive load : 4 A 28 VDC Minimum load : 10 mA 50 mV, 10 A 5 VDC When used above 300 mA 28 VDC, the gold plating is removed on contact areas and is considered only as a protection against oxidation during storage. Initial contact resistance : 10 m max. Insulation resistance : 1,000 M min. at 500 VDC Dielectric strength : 1,000 Vrms 50 Hz min. between terminals 2,000 Vrms 50 Hz min. between poles 2,000 Vrms 50 Hz min. between terminals and frame Contact bounce : 2 ms max. Electrical life : - At 4 A 28 VDC : 10,000 cycles - At low level (50 mV 10 mA) : 150,000 cycles Volts 250 VAC 125 VAC 48 VDC 28 VDC 5 VDC 50 mV Amps 10A 10mA 1 A 2 A 4 A The company reserves the right to change specifications without notice. 1 SW-13000X778MOM-1911 PANEL SWITCHES13000X778 series High performance pushbutton switches threaded bushing 11.9 mm momentary ENVIRONMENTAL SPECIFICATIONS SEALING Front panel sealing : IP67 according to IEC 60529 Front panel sealing by two O-rings Shock test : 50 g - 11 ms (IEC 68-2-27) Panel seal withstands 1 bar pressure and Vibrations : 10-500 Hz - 10 g (IEC68-2-6) remains sealed even when the switch is operated. Operating temperature : -40 C to +85 C (-40 F to +185 F) Epoxy sealed terminals Humidity test : 56 days, 93 % R.H., 40 C (IEC 68-2-3) Splash-proof case Salt spray test : 96 hours (IEC 68-2-11) GENERAL SPECIFICATIONS - O-ring Total travel : 2 mm (.078) - Pre-travel : 1 mm (.039) Torque : 1.50 Nm (1.10 Ft.lb) max. applied to nut Panel thickness : 5 mm (.196) max. TERMINALS MATERIALS Case : diallylphthalate (DAP) with PBT external shell (epoxy sealed) 1.00 (.039) 1.20 Actuator : brass, black chrome plated (.047) 2.50 (.098) Bushing : brass, black chrome plated Contacts : silver inlay - gold plated over nickel barrier APEM products may be recycled at end-of-life for the re-claiming of valuable metal components. ELECTRICAL FUNCTION FLAT AGENCY APPROVALS CECC 96401-001 Many double pole models have full CECC approval. Consult factory for details of approved models. To 1 3 2 order switches marked CECC, complete appropriate box of ordering format. PANEL CUT-OUT 12.00 (.472 DIA) 5.10 (.200) 2 PANEL SWITCHES 1.70 (.066) 4.10 (.161) 8.60 (.338)