9000 series Subminiature momentary pushbutton switches Distinctive features and pecifications UG1006-A Panel and PC mount models, horizontal or vertical Self-cleaning and butt action contacts Several plunger options B ELECTRICAL SPECIFICATIONS Max. current/voltage rating with resistive load : 100mA 30VDC Initial contact resistance : 30 m max. Insulation resistance : 1.000 M min. at 500VDC Dielectric strength : 500 Vrms 50 Hz min. between terminals 1.000 Vrms 50 Hz min. between terminals and frame Electrical life at full load : 9100 - 9200N and 9500N : 250.000 cycles 9200 - 9500 : 100.000 cycles MATERIALS GENERAL SPECIFICATIONS Case : Pa6T Torque : 0,5 Nm (.590 Ft.lb) max. applied to nut Actuator : polyamide, glass Operating temperature : -30C to +65C filled Panel thickness : 1,50 mm (.059) max. Bushing : brass, nickel plated Travels : see table below Contacts : Tolerance : +/- 0,3 mm (.011) CD : brass, gold plated Terminal seal : epoxy 9533-9233 9532-9232 9533N 9233N-9133 Total travel 1,10 (.043) 1,80 (.070) 1 (.039) Pre-travel 0,80 (.031) 1,00 (.039) - Over travel 0,30 (.011) 0,75 (.029) - B-14 www.apem.com APEM 9000 series Subminiature momentary pushbutton switches Overview 9 SERIES Number of poles Electrical functions 3 Single pole 2 Normally closed (NC) 3 Normally open (NO) Terminals, case and bushing Case height 8 (.314) B 2 Straight terminals - threaded bushing 2..Y Tall bracket - plain bushing 2..WW Right angle terminals - plain bushing 5 Solder lugs - threaded bushing Case height 6,1 (.240) 1 Straight terminals - threaded bushing - 7,10 (.279) PCB to panel 1..Y Short bracket - plain bushing 1..WW Right angle terminals - plain bushing 2..N Straight terminals - threaded bushing - 8,90 (.350) PCB to panel 2..NY Tall bracket - plain bushing 5..N Solder lugs - threaded bushing Contact materials Sealing Plunger Caps Mounting bezel CD Gold plated brass Blank Epoxy sealed Blank Standard For plunger -4 U4922 (standard) terminals standard -0 Flush U4310 Height 4 (.157) For 9500 model K Front panel sealing -4 Long U4320 Height 3,9 (.153) only. by two O-rings ABOUTTHISSERIES On the following pages, you will find successively : - model structure of switches - their options in the same order as in above chart Dimensions : first dimensions are in mm while inches are shown as bracketted numbers. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Sealing boots are available to protect the switches. They are presented in section H. Mounting accessories : standard hardware supplied with all threaded bushing models : 1 nickel plated hex nut 5 (.196) across flats, part number U544. This nut is presented after model structure of switches. Packaging unit : 100 pieces. APEM www.apem.com B-15