9000 series
Momentary pushbutton switches
Distinctive features and specifications
Two case lengths
Three electrical functions
Sealing options
Model X1146 with 16 (.630) bushing
B
ELECTRICAL SPECIFICATIONS
Max. current/voltage rating with resistive load :
- silver contact (A) : 0,3A 250VAC - 0,6A 125VAC - 1A 30VDC
- gold plated contacts (CD) : 100mA 30VDC
Initial contact resistance : 50 m max.
Insulation resistance : 1.000 M min. at 500VDC
Dielectric strength :
1.000 Vrms 50 Hz min. between terminals
1.500 Vrms 50 Hz min. between terminals and frame
Electrical life : 250.000 cycles
MATERIALS GENERAL SPECIFICATIONS
Case : thermoplastique UL94-V0 Total travel :
Actuator : polyamide, glass
9600-9400-9400Y 9600N-9400N
filled
Bushing : brass, nickel plated
Functions 3 and 5 Function 2 Function 3
Contacts :
1,3 mm 2 mm 0,9 mm
A : silver
CD : brass, gold plated
Terminal seal : epoxy Torque : 1,25 Nm (.922 Ft.lb) max. applied to nut
Operating temperature : -30C to +65C
B-50 www.apem.com APEM 9000 series
Momentary pushbutton switches
Overview
9
SERIES
Number of poles Electrical functions
3 Single pole 2 Normally closed (NC)
3 Normally open (NO)
5 Combined (NC/NO)
Terminals, case and bushing
B
Case length 11,2 (.440) All models have 6,35 (1/4) threaded bushing.
4 Straight PC terminals
6 Solder lug terminals
6..Z1 Quick-connect terminals
4..Y Straight PC terminals, bracket mounting
Case length 8,5 (.334)
4..N Straight PC terminals
6..N Solder lug terminals
6..NZ1 Quick-connect terminals
Contact materials Sealing Special options Caps
A Silver Blank No sealing F Tin dipped terminals U900 5 (.196)
CD Brass, gold B Epoxy sealed (for PC terminals only) U1140 8 (.314)
plated terminals X1146 Bushing 16 (.630) U1720 9,4 (.370)
K Front panel sealing X601 Special contact, lower rating U480 10 (.393) standard
by two O-rings U630 15 (.590)
U2430 Square - Height 4 (.157)
U2020 Square - Height 6 (.236)
ABOUT THIS SERIES
On the following pages, you will find successively :
- model structure of switches
- their options in the same order as in above chart
Dimensions : first dimensions are in mm while inches are shown as bracketted numbers.
NOTICE : please note that not all combinations of above numbers are available.
Refer to the following pages for further information.
Sealing boots are available to protect the switches against dust and water. They are presented in section H.
Mounting accessories : standard hardware supplied with all switches : 2 hex nuts 8 mm (.314) across flats and 1 lockwasher.
Standard and special hardware available are presented in section I.
Packaging unit : 50 pieces, except for 9400Y (25 pieces)
APEM www.apem.com B-51