CJ-N3DP0013N Apem

CJ series Proportional, multi-function hand grip controllers non-contacting Hall effect technology DISTINCTIVE FEATURES One and two axis control Analog outputs Rated for 5 million lifecycles CAN bus and USB output options Redundant output available ENVIRONMENTAL SPECIFICATIONS Operating Temperature: -40 C to +85 C (-40 F to +185 F) Storage Temperature: -40 C to +85 C (-40 F to +185 F) Above Panel Sealing: Up to IP67 (subject to handle configuration) EMC Immunity Level: EN61000-4-3: 2006 EMC Emissions Level: EN61000-4-8: 2009 ESD: EN61000-4-2: 2008 ELECTRICAL SPECIFICATIONS Supply voltage range: 5.00 VDC 0.01 VDC Reverse polarity Max: -10 VDC Ratiometric Output Voltage: See options Transient overvoltage max: 16 V Output Impedance: 2 Return to Center Voltage Tolerance: 200 mV initial Supply Current: 13 mA per sensor MECHANICAL SPECIFICATIONS Operating Force: 7.6 N (1.70 lbf) Maximum Vertical Load: 444.8 N (100 lbf) Maximum Horizontal Load: 649.4 N (146 lbf) Mechanical Angle of Movement: 40 (20) Expected Life: 10 million lifecycles Mass /weight: 544.3 g (19.2 oz) Lever Action (centering): Spring * Operating force: configuration option L The company reserves the right to change specifications without notice. 1 JST-CJ-2112 JOYSTICKSCJ series Proportional, multi-function industrial hand grip controllers non-contacting Hall effect technology PANEL CUT-OUT MATERIALS Body: Glass Filled Nylon 57.15 30.48 (2.25) (1.20) Handles: Glass Filled Nylon TERMINATION 60.9 6 (2.40) The CJ series is fitted with a 18 0.5 AWG22 wire harness. Further non-standard connectors and cable 30.4 8 (1.20) options are available upon request. WIRE COLOR SIGNAL R 6.35 (0.25) 4 plcs 60.96 RED 5 VDC for analog outputs within voltage (2.40) range 0 VDC to 5 VDC 7 VDC to 35 VDC for voltage regulator options BLACK Ground BLUE X axis data YELLOW Y axis data GREEN Z axis data CAN J1939 INTERFACE BLUE / WHITE Redundant X axis SPECIFICATION YELLOW / BLACK Redundant Y axis GREEN / BLACK Redundant Z axis The CJ Series utilizes redundant Hall effect sensors ORANGE Button 1 to measure the primary X and Y axis. The CAN controller support various button configurations as VIOLET Button 2 well as proportional thumbwheels and mini-joysticks GREY Button 3 for additional axis data. BROWN Button 4 All axis and button data are delivered on a CAN 2.0B compliant physical interface. Two additional signals GRAY / BLACK Button 5 allow configuration of the controller Source Address. BLUE / WHITE Button 6 Controller messages are delivered per the SAE J1939-71 message protocol. YELLOW / BLACK Button 7 GREEN / BLACK Button 8 CAN 2.0B INTERFACE PARAMETERS VIOLET / WHITE Button 9 WHITE Common Baud rate: 250 KHz Transmission repetition rate: 50ms BJMl/EJMl interval time: 20ms Terminating resistor: No (available by special request to factory) Connection to Deutsch DTM04-6P connector: Pin Color Function 1 White CAN Lo 2 Green CAN Hi 3 Blue Source Address SEL 1 4 Orange Source Address SEL 0 5 Black Ground 6 Red 6 - 35 VDC 2 JOYSTICKS