IC series Pushbutton switches for harsh environments - short case - bushing 12 mm - momentary Distinctive features and specifications Momentary with short case, reduced behind-panel depth Tactile feedback Flat round actuator for optional marking Glossy actuator option (round curved only) Sealed to IP67 ENVIRONMENTAL SPECIFICATIONS GENERAL SPECIFICATIONS Front panel sealing : IP67 according to IEC 60529 Panel thickness : 1,5 mm (.059) min. Shock resistance : 100 g according to IEC 512-4, test 6c 4 mm (.157 max.) Vibration resistance : 10-500Hz - 10 g according to IEC 512-4, test 6d Total travel : 1,7 mm (.067)+/- 0,3 mm Salt spray : IEC 512-6, test 11f Typical operating force : 4N +/- 2N Robustness : IK06 according to EN 50102 (1 joule) Mechanical life : 1.000.000 cycles Operating temperature : -40C to +85C Torque : 1,5 Nm max. applied to nut Soldering : 320C max. for 3 sec. ELECTRICAL SPECIFICATIONS MATERIALS Max. current/voltage rating with resistive load : 0,2A 48VDC, 500.000 cycles Case : thermoplastic UL94-V0 0,5A 48VAC, 500.000 cycles Actuator : polyamide 6/6 Initial contact resistance : 50 m max. Bushing/bezel : zinc die-cast Insulation resistance : 1 G min. at 500VDC (zamac), black painted Dielectric strength : 1.500 Vrms 50 HZ between terminals Contacts : brass, gold plated Multi-wire lead AWG20, 2 section 0,6 mm Terminal seal : epoxy MOUNTING Panel cut-out Matrix mounting Back of panel space requirement 20.00 20.00 12.90 (.787) (.787) (.507) 1 13.60 (.535DIA) 13.50 (.531DIA) O-ring APEM www.apem.com 1 1.50min-4Max (.059 min-.157max) 20.00 (.787)IC series Pushbutton switches for harsh environments - short case - bushing 12 mm - momentary Overview IC SERIES Electrical function Terminals Contacts Actuator shape 3 Normally open S Solder lugs CD Brass, gold C Square (NO) F Flying leads plated R Round, curved P Round, flat P Straight PC Z1 Quick-connect B Round curved with gloss finish Actuator colour Options 1 Blue 100 Satin chrome 2 Black bezel 3 Green 101 Bright chrome 4 Grey bezel 5 Yellow 104 High actuator 6 Red (round 7/1 White models only) 8 Bright chrome 9 Orange A Satin chrome B Dark blue ABOUT THIS SERIES On the following pages, you will find successively : model structure of switches and options in the same order as in above chart Dimensions : first dimensions are in mm while inches are shown as bracketed numbers. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. A sealing boot is available to protect the switches against frost and sand. It is presented at the end of this catalogue. Mounting accessories : Standard hardware supplied : 1 hex nut 14 mm (.551) across flats and 1 O-ring. Hex nut part number U166. Packaging unit : 25 pieces 2 www.apem.com APEM