IZ series Rear mounted sealed pushbutton switches bushing 16 mm latching DISTINCTIVE FEATURES Rear mounting for easier installation Latching action models Sealed to IP67 Illuminated or non-illuminated Flat actuator for optional marking ENVIRONMENTAL SPECIFICATIONS Front panel sealing : IP67 according to IEC 60529 Shock resistance : 100 g according to IEC 512-4, test 6c Vibration resistance : 10-500Hz - 10 g according to IEC 512-4, test 6d Salt spray : IEC 512-6, test 11f Operating temperature : -40 C to +85 C (-40 F to +185 F) ELECTRICAL SPECIFICATIONS Max. current/voltage rating with resistive load : 100 mA 24 VDC - 200,000 cycles Initial contact resistance : 100 m max. Insulation resistance : 1 G min. at 500 VDC Dielectric strength : 1.500 Vrms 50 Hz between terminals LED COMPONENT SPECIFICATIONS LED color Forward current Typ. forward voltage Max. forward voltage A resistor must be series-connected by the user. Super red (L0S) 20 mA 1.95 V 1.95 V Resistor value = supply voltage - LED forward voltage Yellow (L0Y) 20 mA 2 V 2.05 V LED forward current Green (L0G) 20 mA 2.1 V 2.5 V On flying lead versions, the LED resistor can be integrated by APEM on request. Blue (L0B) 20 mA 3.2 V 4 V The company reserves the right to change specifications without notice. 1 SW-IZLATCH-1801 PANEL SWITCHESIZ series Rear mounted sealed pushbutton switches bushing 16 mm latching GENERAL SPECIFICATIONS TERMINALS Panel thickness : 3 mm (.118) max. Total travel : 2.5 mm (.098) 0.3 mm Typical operating force : 5 N 2 N 1.40 (.055) 1.10X0.50 1.20 Low level or mechanical life : 200,000 cycles (.043X.019) (.047) 2.80 2.80 Torque : 0.7 Nm max. applied to nut (.110) (.110) Soldering : 320 C (662 F) max. for 3 sec. Solder lug S Straight P Quick-connect Z ELECTRICAL FUNCTIONS MATERIALS CIPNLF1COS CISCOSZ-A Case : thermoplastic UL94-V0 ILLUMINATED MODELS Plunger : polyamide DESSIN ECH 0.9 DESSIN ECH 0.9 Bushing/bezel : polyamide 5-05-03 17.10.01 Contacts : silver, gold plated 2 Multi-wire leads AWG20, section 0.6 mm 2 LED wire : AWG26, section 0.12 mm (+) (+) Lens : polycarbonate (-) (-) OFF ON Terminal seal : epoxy APEM products may be recycled at end-of-life for the re-claiming of valuable metal components. NON-ILLUMINATED MODELS MOUNTING PANEL CUT-OUT 16.10 OFF ON (.633DIA) 1 15.10 (.594) - Flat seal MATRIX MOUNTING 22.00 (.866) 16.10 (.633DIA) 15.10 (.594) 2 PANEL SWITCHES 3.00 Maxi 22.00 (.118MAX) (.866) 2.30 (.090) 3.20 (.125) 4.20 (.165) 3.40 (.133) 2.40 (.094) 8.40 (.330)