TinkerKit Tilt Sensor Overview The Tilt Sensor can detect when it is at an angle. Output: This module contains two contacts and a small metal ball. When the sensor is in its upright position, the ball bridges the two contacts, completing the circuit. When the board is tilted, the ball moves, and the circuit opens. When upright, the module outputs 5V and when it is tilted, it outputs 0V. When connected to an input on the Arduino using the TinkerKit Shield, you can expect to read a value of 1023 when in its upright position and 0 when it is titled. Module description: this module features a Tilt Sensor, a signal amplifier, the standard TinkerKit 3pin connector, a green LED that signals that the module is correctly powered and a yellow LED that lights up when a connection is made (the sensor is upright). This module is a SENSOR. The connector is an OUTPUT which must be connected to one of the INPUT connectors on the TinkerKit Shield. Code Example /* Tilt Turns on and off a T010111 LED Module connected to O0 (digital pin 11), triggered by a T000190 Tilt Sensor attached to I0 (analog pin 0). created 2005 by DojoDave <