Bel Power Solutions MAP140 Series provides a full range of options and up to 30 watts more power than comparable products in this industry-standard footprint. With a universal input from 85 to 264 VAC 3 and power densities up to 2.6 watts/inch , the MAP140 meets the most rigorous requirements of commercial, industrial, and datacom systems. Rated for use in convection and forced-air cooled (200 LFM) applications, the MAP140 delivers dependable power with a Mean Time Between Failures (MTBF) in excess of 180,000 hours. In addition to UL, CSA, and NEMKO regulatory compliance, the MAP140 displays the CE Mark. RoHS Lead-Solder-Exemption Compliant Universal Input 85-264 VAC Input Transient & ESD Compliance to EN61000-4-2/-3/-4 CE marked to Low Voltage Directive Industry-Standard Footprint: 7.0 x 4.3 x 1.8 inch (177.8 x 109.2 x 45.7 mm) Remote Sense and Overvoltage Protection Power Fail Signal Standard on MAP140-3000P, Optional on MAP140- 1012 and MAP140-1024G Optional Overtemperature Protection, L-bracket and Cover2 MAP140 Series CONVECTION FORCED RIPPLE OUTPUT ADJUSTMENT LINE LOAD INITIAL SETTING 5 MODEL COOLED AIR & VOLTAGE RANGE REGULATION REGULATION ACCURACY 1 2 CURRENT CURRENT NOISE 3 3 MAP140-1012* 12V/15V 11.0V to 16.0V 9.2/7.3A 12.5A/10A 0.1% 0.5% 1% 11.97V to 12.03V 3 3 MAP140-1024G 24V/28V 22.8V to 29.2V 4.6/4A 6.3A/5.4A 0.1% 0.5% 1% 23.95V to 24.05V MAP140-1048* 48V 45.6V to 54.0V 2.3A 3.1A 0.1% 0.5% 1% 47.9V to 48.1V PEAK OUTPUT ADJUSTMENT OUTPUT LINE LOAD RIPPLE & INITIAL SETTING 5 MODEL OUTPUT 4 2 VOLTAGE RANGE CURRENT REGULATION REGULATION NOISE ACCURACY 4 CURRENT 5.09V to +5V 4.75V to 5.25V 16A/25A 20A/25A 0.2% 1% 1% PK PK 5.11V 11.97V to MAP140-3000P* +12V Fixed 4A/9A PK 4A/9A PK 0.1% 2% 1% 12.03V -11.4V to - -12V Fixed 1A/1.5A 1A/1.5A 0.1% 2% 1% PK PK 12.6V 1 With minimum 200 LFM forced air cooling. 2 Maximum peak to peak noise expressed as a percentage of output voltage, 20MHz bandwidth. 3 MAP140-1012 output currents are expressed as 12V/15V operation. MAP140-1024G output currents are expressed as 24V/28V operation. 4 Peak loads up to 140 Watts for 60 seconds or less are acceptable, (10% duty cycle max.). Peak power must not exceed 140 watts. 5 Non-G models use lead solder exemption and are not recommended for new designs. Oooooo Model numbers highlighted in yellow are not recommended for new designs. * Obsolete tech.support psbel.com