The SGP1200-12G is a 1133 W, power-factor- corrected (PFC) AC-DC front-end which provides a 12 VDC output for datacom, telecom, and other distributed power applications. The SGP1200-12G meets international safety requirements and is CE marked to the Low Voltage Directive (LVD). The supplys compact dimensions of 11 x 3.2 x 1.57 inches 279 x 81 x 40 mm make it ideal for Wide input voltage range (90-264 VAC) with PFC 1U rack mounting. Its internal fan cooling assists providing a normal operating temperature range Active current share of -10C to +50C. Incorporates remote sense 2 I C interface status monitoring Standby voltage of 3.3 VDC 4 A Data Communications Overtemperature, overcurrent, overvoltage, and Telecommunications undervoltage protection Distributed Power Systems 1U or 2U height configurations Status LED provides indicators for input, output, and temperature plus fan status North America +1-866.513.2839 Asia-Pacific +86.755.29885888 Europe, Middle East +353 61 225 977 tech.support psbel.com 2015 Bel Power Solutions, Inc. BCD.00022 AB NOMINAL MAXIMUM RIPPLE & NOISE MODEL REGULATION OUTPUT VOLTAGE OUTPUT CURRENT 20 MHz BW 12 VDC 93.3 A 1 % 100 mV SGP1200-12G 3.3 VDC (Standby) 4 A 2 % 50 mV 12 VDC 93.3 A 1 % 100 mV SGP1200-12S204G 5 VDC (Standby) 2.6 A 2 % 50 mV PARAMETER CONDITIONS / DESCRIPTION MIN NOM MAX UNITS AC Input Voltage Single-phase continuous input range. 90 264 VAC Input Frequency AC input. 47 63 Hz Hold-up Time After last AC line peak at full power. At 120 VAC. 12 ms Input Current At full-rated load. At 120 VAC <12 Arms Inrush Surge Current Excluding Xcap. Under all conditions. <30 Apk Power Factor Per EN61000-3-2 at 30% or higher load > 0.95 W/VA PARAMETER CONDITIONS / DESCRIPTION MIN NOM MAX UNITS 110 VAC 70%FL 86.5 87.5 % 110 VAC 100% FL 84.5 85.5 % 1 Efficiency 230 VAC 70%FL 89 90 % 230 VAC 100% FL 87.5 89 % Minimum Load Main Output 12 V minimum loading required to maintain regulation. 0.5 A Output Power 1133 W Overshoot <5 % Load Step of 50% Full load Transient Response Note: Minimum starting load: <5 % 12 V -> 9 A, 3V3 -> 0.2 A Turn-On Delay with Time required for initial output voltage stabilization after application of <3000 ms PS ON signal AC input or ON/OFF signal. Output Regulation See Model Selection table above PARAMETER CONDITIONS / DESCRIPTION I2C Interface BCA.00009 EEPROM Data SGP1200-12MM 1 The fan is considered to be part of the load. 2 2 ReferenceI C Management Interfac andEEPROM Table of Content documents for SGP1200-12G (consult factory). +1.866.513.2839 tech.support psbel.com 2015 Bel Power Solutions, Inc. BCD.00022 AB