PRB-02 Bitscope

T K N U P E N Voltage Derating Curve Oscilloscope Probe Kit Model. PRB-02 10kV 2kV 1kV 100V 10V 10KHz 100KHz 1MHz 10MHz 100MHz 1GHz Frequency Fig.1 Made in Taiwan Version:HF-E0101A R G R E D VoltsIntroduction Specifications The PRB-02 is a low-input capacitance high voltage oscillo- Attenuation Ratio 100:1 scope probe designed and calibrated for use with instruments Bandwidth DC to 300MHz having an input impedance of 1M shunted by 20pF. However, Rise Time 1.16nS it may be compensated for use with instruments having an input capacitance of 10 to 30pF. The PRB-02 probe is also Input Capacitance Approx. 5.5pF compatible with readout function oscilloscopes that Compensation Range 10 to 30 pF automatically detect probe attenuation and adjust the Working Voltage 1500Vrms CAT II (2000V DC incl. peak AC) scale readout accordingly. derating with frequency, (see Fig.1) 0 0 Operating Temperature 0 C to 50 C 0 Safety Instructions Humidity 85% RH or less (at 35 C) Safety Meets E61010-031 CAT II Review the following safety precautions to avoid injury and Cable Length 1.35 Meter prevent damage to this product or any products connected to it. To avoid potential hazards, use this product only as specied. The common terminal is at ground potential. Do not connect the common terminal to elevated voltages. Do not operate in an explosive atmosphere. Keep product surfaces clean and dry. If your probe requires cleaning, disconnect it from the instrument and clean it with mild detergent and water. Make sure the probe is completely dry before reconnecting it to the instrument. Compensation Adjustment The following adjustment is required whenever the probe is transferred from one oscilloscope or input channel to another. Connect the probe to the oscilloscope, apply a 1KHz square wave to the probe tip and adjust the oscilloscope controls to display a few cycles of the waveform. Adjust the trimmer located in the BNC box for a at topped square wave.