HLMP-WL02, HLMP-WG02 High Intensity AlInGaP LED Lamps Data Sheet Description Features T-1 3/4 (5 mm) General Purpose LED Lamps This 5 mm LED lamps is specially designed for applica- tions requiring higher levels of intensity than is achieved AlInGaP SunPower Intensity with a standard lamp. The 5 mm lamp is available with 65 High Light Output degree viewing angle. Tinted Diffused Lens Package Dimensions Amber and Red Available on Tape and Reel 5.00 0.20 (0.197 0.008) Applications 1.14 0.20 General Purpose 8.71 0.20 (0.045 0.008) (0.343 0.008 Consumer Goods Indicator Lights Device Selection Guide 2.35 (0.093) MAX. T-1 (5 mm) Lamp Luminous Viewing 31.60 MIN. Intensity Angle (1.244) 0.70 (0.028) MAX. Min. mcd, 2q Color Part Number I 20 mA (Degrees) f Amber HLMP-WL02 35 65 Red HLMP- WG02 26 65 CATHODE LEAD Notes: 1. Dominant Wavelength, d, is derived from the CIE Chromaticity Diagram, and represents the color of the lamp. 2. q is the off-axis angle where the luminous intensity is one half the 1/2 on-axis intensity. 0.50 0.10 SQ. TYP. 1.00 3. The luminous intensity is measured on the mechanical axis of the MIN. (0.020 0.004) (0.039) lamp package. 4. The optical axis is closely aligned with the package mechanical axis. 5.80 0.20 (0.228 0.008) CATHODE FLAT 2.54 0.38 (0.100 0.015)Absolute Maximum Ratings at T = 25C A Parameter 5 mm 1,2,3 DC Forward Current 50 mA Peak Pulsed Forward Current 70 mA Average Forward Current 30 mA Reverse Voltage (I = 100 mA) 5 V R LED Junction Temperature 130C Operating Temperature -40C to + 100C Storage Temperature -40C to + 100C Notes: 1. Derate linearly as shown in Figure 4. 2. For long term performance with minimal light output degradation, drive currents between 10 and 30 mA are recommended. 3. Please contact your Avago Technologies sales representative about operating currents below 10 mA. Electrical/Optical Characteristics at T = 25C A Parameter Symbol Min. Typ. Max. Units Test Conditions Forward Voltage V V I = 20 mA F F Amber ( = 590 nm) 2.02 2.4 d Red ( = 626 nm) 1.90 d Reverse Voltage V 5 20 V I = 100 mA R R Peak Wavelength nm Peak of Wavelength of Spectral PEAK Amber 592 Distribution at I = 20 mA F Red 635 Spectral Halfwidth D 17 nm Wavelength Width at Spectral Distri- bution Power point at I = 20 mA F -t/ts Speed of Response t 20 ns Exponential Time Constant, e s Capacitance C 40 pF V = 0, f = 1 MHz F Thermal Resistance Rq 240 C/W LED Junction-to-Cathode Lead J-PIN 1 Luminous Efficacy hv lm/W Emitted Luminous Power/Emitted Amber 500 RadiantPower Red 155 Note: 1. The radiant intensity, Ie, in watts per steridian, may be found from the equation Ie = Iv/hv, where Iv is the luminous intensity in candelas and hv is the luminous efficacy in lumens/watt. 2