G50101106 Carlo Gavazzi

Transmitter for Digital Signals Du line Type G 5010 1106 Fieldbus Installationbus Single channel transmitter Contact input Input pulse prolongation Codeable LED output e.g. for feedback purposes Supplied by Dupline , no external supply required Mini-E housing Direct wall or DIN-rail mounting Channel coding by GAP 1605 Product De scrip tion Ordering Key G 5010 1106 Dupline-powered single- a short charge current pulse Type: Dupline channel transmitter in Mini-E ensures that the contacts are Mini-E housing housing with contact input. kept clean. On the front of the Function Especially well suited in places module, there is a red LED No. of channels where no power supply is which can be coded for any Input type available. On the input, there Dupline channel address is a built-in pulse-prolongation for indication of channel ON which ensures that even short status. There are only 4 termi- input pulses are transmitted. nals on the module: 2 for Upon activation of the input Dupline and 2 for the input. Type Selection Supply Spec i fi ca tions Supply Ordering No. Power supply Supplied by Dupline 1 channel Current consumption Contact with LED OFF Typ. 450 A with LED ON Typ. 1.2 mA Supplied by Dupline G 5010 1106 Input Spec i fi ca tions General Spec i fi ca tions Inputs 1 contact Environment Open loop voltage 2.5 VDC Degree of protection IP 20 Short-circuit current 17 A Pollution degree 3 (IEC 60664) Operating time for signal1 < 1 pulse train + 10 ms Operating temperature -20 to +50C (-4 to +122F) Operating time for signal0 < 1 pulse train + 500 ms Storage temperature -50 to +85C (-58 to +185F) Contact resistance < 1 k Humidity (non-condensing) 20 to 80% Input pulse prolongation min. 272 ms Mechanical re sist ance Cable length < 3 m Shock 15 G (11 ms) Dielectric voltage Vibration 2 G (6 to 55 Hz) Input - Dupline None Dimensions 49 x 22.5 x 56 mm (L x W x H) Material PC/ABS blend Specifications are subject to change without notice (01.02.2007) 1 Dupline is a registered trademark. A product of the CARLO GAVAZZI GroupG 5010 1106 Du line Fieldbus Installationbus Dimensions (mm) Mode of Operation Dupline -powered 1-channel respective data sheet. Please Mini E-housing transmitter with contact input. note that a special cable There is a built-in pulse-pro- (GAP-TPH-CAB) is required to longation on the input to connect the GAP 1605 to the 47.4 22.5 15 ensure that even short input programming plug behind the pulses are transmitted. On front plate of G 5010 1106. the front of the module there The channel address for the is a red LED which can be input is selected under I/O-1 coded to indicate the status on the GAP 1605 and the of any Dupline -channel. channel address for the LED 4 x 3.4 The input and the LED out- output under I/O-5. put can be coded individual- ly by means of the code pro- If an address is assigned to grammer GAP 1605. For I/O-3 or I/O-4, this address details, please refer to the will be activated continuously. Accessories Programming cable to GAP 1605 GAP-TPH-CAB Wiring Diagram S Dot LED The programming cable must always be connected with the dot pointing S: signal wire towards the LED. 2 Specifications are subject to change without notice (01.02.2007) Dupline is a registered trademark. A product of the CARLO GAVAZZI Group 55.4 56 49