SAFETY DATA SHEET CircuitWorks Rosin Flux Remover Pen Section 1. Identification GHS product identifier : CircuitWorks Rosin Flux Remover Pen Product code : CW9200 Chemical name : Flux Remover Pen Other means of : CW9200 identification Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Not applicable. Supplier s details : Chemtronics 8125 Cobb Center Drive Kennesaw, GA 30152 Tel. 770-424-4888 or toll free 800-645-5244 Emergency telephone : Chemtrec - 1-800-424-9300 or collect 703-527-3887 24/7 number (with hours of operation) Section 2. Hazards identification OSHA/HCS status : This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200). Classification of the : FLAMMABLE LIQUIDS - Category 2 EYE IRRITATION - Category 2A substance or mixture GHS label elements Hazard pictograms : Signal word : Danger Hazard statements : Highly flammable liquid and vapor. Causes serious eye irritation. Precautionary statements Prevention : Wear protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Use explosion- proof electrical, ventilating, lighting and all material-handling equipment. Use only non- sparking tools. Take precautionary measures against static discharge. Keep container tightly closed. Wash hands thoroughly after handling. Response : IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or shower. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical attention. Storage : Store in a well-ventilated place. Keep cool. Disposal : Dispose of contents and container in accordance with all local, regional, national and international regulations. Hazards not otherwise : None known. classified Date of issue/Date of revision : 7/24/2018 Date of previous issue : 7/24/2018 Version : 2 1/13CircuitWorks Rosin Flux Remover Pen Section 3. Composition/information on ingredients Substance/mixture : Mixture Chemical name : Flux Remover Pen Other means of : CW9200 identification Ingredient name % CAS number Isopropyl alcohol 50 - 75 67-63-0 hexamethyldisiloxane 25 - 50 107-46-0 propyl acetate 10 109-60-4 1-methoxy-2-propanol 5 107-98-2 Any concentration shown as a range is to protect confidentiality or is due to batch variation. There are no additional ingredients present which, within the current knowledge of the supplier and in the concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in this section. Occupational exposure limits, if available, are listed in Section 8. Section 4. First aid measures Description of necessary first aid measures Eye contact : Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10 minutes. Get medical attention. Inhalation : Remove victim to fresh air and keep at rest in a position comfortable for breathing. If not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel. It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation. Get medical attention if adverse health effects persist or are severe. If unconscious, place in recovery position and get medical attention immediately. Maintain an open airway. Loosen tight clothing such as a collar, tie, belt or waistband. Skin contact : Flush contaminated skin with plenty of water. Remove contaminated clothing and shoes. Get medical attention if symptoms occur. Wash clothing before reuse. Clean shoes thoroughly before reuse. Ingestion : Wash out mouth with water. Remove dentures if any. Remove victim to fresh air and keep at rest in a position comfortable for breathing. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Stop if the exposed person feels sick as vomiting may be dangerous. Do not induce vomiting unless directed to do so by medical personnel. If vomiting occurs, the head should be kept low so that vomit does not enter the lungs. Get medical attention if adverse health effects persist or are severe. Never give anything by mouth to an unconscious person. If unconscious, place in recovery position and get medical attention immediately. Maintain an open airway. Loosen tight clothing such as a collar, tie, belt or waistband. Most important symptoms/effects, acute and delayed Potential acute health effects Eye contact : Causes serious eye irritation. Inhalation : Can cause central nervous system (CNS) depression. Skin contact : No known significant effects or critical hazards. Ingestion : Do not ingest. If swallowed then seek immediate medical assistance. Over-exposure signs/symptoms Eye contact : Adverse symptoms may include the following: pain or irritation watering redness Date of issue/Date of revision : 7/24/2018 Date of previous issue : 7/24/2018 Version : 2 2/13