V8910BK V8910BK Datasheet revision 1.0 www.chipquik.com Vacuum Pick & Place Tool Specifications Vacuum Pick & Place Tool Kit Static Dissipative Buna-N Cups Comes with: 3 bent probes 1 straight probe 1/8 cup x 1 1/4 cup x 2 3/8 cup x 1 High quality pick-and-place tool How to Use 1. Select a tip with a rubber vacuum cup that is slightly smaller than the area at which you want to pick-and-place the part from. 2. Push the vacuum cup, or vacuum cup and probe tip, snugly onto the end of the vacuum tool. 3. Make sure that there is no dust on the rubber vacuum cup. Note: if preferred, the rubber cups can be placed directly on the vacuum tool without using the straight or bent probes. 4. Depress the button on the side of the vacuum tool, and place the soft rubber vacuum cup squarely onto the pick-and- place part, then release the button. This will create a vacuum that will hold the part firmly. Note: it is normal for the vacuum created to slowly lose its strength over 30-60 seconds, so placing your part within this time is recommended. 5. Move the part to where you want to place it, lower it to the board, then squeeze the button again to release the part. Applications Pick-and-place of metal, plastic, or any parts having a smooth non-porous top surface area that the rubber vacuum cup can seal against. For larger parts, use the larger vacuum cup. 1 1994-2015 Chip Quik Inc. X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Desoldering Braid / Solder Removal category: Click to view products by Chip Quik manufacturer: Other Similar products are found below : 532505-2 DS03-910-5 T0054487199 T0054486999 DP-CC STDC-102 T0054465499N T0058741815N T0054465299N T0051320399N T0051351199 4036S 6961 9057 9970 9976 DS104 DS115T DS117T DS204 DS206 DS60 ETBB HE80 MP135 MP136 MP137 MP138 MT6 UTC234 T0054460273 T0053411299N 17538 S1069 1811-5F 1830-10F 50-3-100 1813-5F 1833-10F 1810-25F 1823-25F 1824- 25F CL7984 33397-AA 33398-AA 33396-AA 0320705 0320800 0320903 0321200