SLG47105 Preliminary GreenPAK Programmable Mixed-Signal Matrix with High Voltage Features General Description The SLG47105 provides a small, low power component for commonly used Mixed-Signal and H-Bridge functions. The user creates their circuit design by programming the one time programmable (OTP) Non-Volatile Memory (NVM) to configure the interconnect logic, the IO Pins, the High Voltage Pins, and the macrocells of the SLG47105. Configurable PWM macrocells in combination with Special High Voltage outputs will be useful for a motor drive or load drive applications. High Voltage pins allow to design smart level translators or to drive the high voltage high current load. Key Features Two Power Supply Inputs: Four Selectable DFF/LATCH/3-bit LUTs + 8-bit Delay/ 2.5 V (8 %) to 5.0 V (10 %) V Counters DD 3.3 V (10 %) to 12.0 V (10 %) V One Selectable DFF/LATCH/4-bit LUT + 16-bit Delay/ DD2 Four High Voltage High Current Drive GPOs Counter Dual/Single H-Bridge Motor Driver Option Twelve Combination Function Macrocells Quad/Dual/Single Half-Bridge Driver Option Three Selectable DFF/LATCH or 2-bit LUTs Sleep Function One Selectable Programmable Pattern Generator or Low RDS ON High Side + Low Side resistance = 0.4 2-bit LUT 2 A Peak, 1.5 A RMS per H-Bridge (at V = 5 V, DD2 Six Selectable DFF/LATCH or 3-bit LUTs T = 25 C) (Note 1) One Selectable Pipe Delay or Ripple Counter or 3-bit 4 A Peak, 3 A RMS per two H-Bridge connected in LUT parallel (at V = 5 V, T = 25 C) (Note 1) DD2 One Selectable DFF/LATH or 4-bit LUT 2 A Peak, 1.5 A RMS per Half Bridge GPO Two PWM Macrocells (at V = 5 V, T = 25 C) (Note 1) DD2 Flexible 8-bit/7-bit PWM Mode with the Duty Cycle Integrated Protections: Control - Over Current Protection (OCP) 16 Preset Duty Cycle Registers Switching Mode for - Short Circuit Protection (SCP) PWM Sine or Other Waveforms (Note 2) - Under-Voltage Lockout (UVLO) Serial Communications - Temperature Shutdown (TSD) 2 I C Protocol Interface SENSE A, SENSE B Inputs that are Connected to the Programmable Delay with Edge Detector Output Current Comparators for Current Control Additional Logic Function One Deglitch Filter with Edge Fault Signal Indicator Individual per H-bridge: Detectors - OCP Two Oscillators (OSC) - UVLO 2.048 kHz Oscillator - TSD 25 MHz Oscillator Differential Amplifier with Integrator and Comparator for Motor Speed Control Function Analog Temperature Sensor with ACMP Connected Out- Two Current Sense Comparators with Dynamical Vref put Mode POR Two High-Speed General Purpose ACMPs One Time Programmable Memory Modes: UVLO, OCP, TSD, Voltage Monitor, Current Operating Temperature Range: -40 C to 85 C Monitor RoHS Compliant/Halogen-Free One Voltage Reference (Vref) Output 20-pin STQFN: 2 mm x 3 mm x 0.55 mm, 0.4 mm pitch Five Multi-Function Macrocells Applications Smart Locks Toys Personal Computers and Servers HV MOSFET Drivers Video Security Cameras Consumer Electronics LED Matrix Dimmers Motor Drivers Note 1 Power dissipation and thermal limits must be observed. See Section 3.3 Note 2 For all PWM features see Section 13. Datasheet Revision 2.0 9-Jun-2020 1 of 223 CFR0011-120-00 2020 Dialog SemiconductorSLG47105 Preliminary GreenPAK Programmable Mixed-Signal Matrix with High Voltage Features Contents General Description .................................................................................................................................................................1 Key Features.............................................................................................................................................................................1 Applications..............................................................................................................................................................................1 1 Block Diagram ....................................................................................................................................................................10 2 Pinout ..................................................................................................................................................................................11 2.1 Pin Configuration - STQFN- 20L ..........................................................................................................................11 3 Characteristics ...................................................................................................................................................................13 3.1 Absolute Maximum Ratings .................................................................................................................................13 3.2 Electrostatic Discharge Ratings ...........................................................................................................................13 3.3 Recommended Operating Conditions ..................................................................................................................14 3.4 Thermal Information .............................................................................................................................................14 3.5 Electrical Characteristics ......................................................................................................................................14 3.6 HV Output Electrical Characteristic ......................................................................................................................19 3.7 Protection Circuits Electrical Characteristic .........................................................................................................23 3.8 Timing Characteristics ..........................................................................................................................................24 3.9 Counter/Delay Characteristics .............................................................................................................................26 3.10 Oscillator Characteristics ...................................................................................................................................27 3.11 Current Sense Comparator Characteristics .......................................................................................................27 3.12 Differential Amplifier with Integrator and Comparator Characteristics ...............................................................29 3.13 ACMP Characteristics ........................................................................................................................................30 3.14 Analog Temperature Sensor Characteristics .....................................................................................................32 4 User Programmability ........................................................................................................................................................34 5 System Overview ...............................................................................................................................................................35 5.1 GPIO Pins ............................................................................................................................................................35 5.2 High Voltage Output Pins .....................................................................................................................................35 5.3 Connection Matrix ................................................................................................................................................35 5.4 Two Current Sense Comparators ........................................................................................................................35 5.5 Differential Amplifier with Integrator and Comparator ..........................................................................................35 5.6 Two general purpose analog comparators ...........................................................................................................35 5.7 Voltage reference .................................................................................................................................................35 5.8 Twelve Combination Function Macrocells ............................................................................................................35 5.9 Five Multi-Function Macrocells .............................................................................................................................35 5.10 Two PWM Macrocells ........................................................................................................................................35 5.11 Serial Communication ........................................................................................................................................36 5.12 Programmable Delay .........................................................................................................................................36 5.13 Additional Logic Function ...................................................................................................................................36 5.14 Two Oscillators ...................................................................................................................................................36 5.15 Dual V DD .....................................................................................................................................................................................................36 6 Input/Output Pins ...............................................................................................................................................................37 6.1 GPIO Pins ............................................................................................................................................................37 6.2 GPI Pin .................................................................................................................................................................37 6.3 HV GPO Pins .......................................................................................................................................................37 6.4 Pull-Up/Down Resistors .......................................................................................................................................37 6.5 Fast Pull-Up/Down during Power-Up ...................................................................................................................37 6.6 GPI IO Structure (for V Group) .........................................................................................................................38 DD 2 6.7 I C Mode IO Structure (for V Group) ................................................................................................................39 DD 6.8 Matrix OE IO Structure (for V Group) ...............................................................................................................41 DD 6.9 GPO Matrix OE Structure (For V Group) ........................................................................................................42 DD2 7 High Voltage Output Modes ..............................................................................................................................................44 7.1 Full-Bridge Mode ..................................................................................................................................................46 7.2 Half bridge mode ..................................................................................................................................................49 7.3 Pre-Driver Mode ...................................................................................................................................................49 7.4 Parallel Connection of HV GPO ...........................................................................................................................49 7.5 Protection Circuits ................................................................................................................................................50 7.6 PWM Voltage Control ...........................................................................................................................................51 Datasheet Revision 2.0 9-Jun-2020 2 of 223 CFR0011-120-00 2020 Dialog Semiconductor