74LVC1G126QSE-7 Diodes Incorporated

74LVC1G126Q SINGLE BUFFER GATE WITH 3-STATE OUTPUT Description Pin Assignments The 74LVC1G126Q is an automotive-compliant, single, non-inverting buffer/bus driver with a 3-state output. The output enters a high- impedance state when a LOW level is applied to the output enable ( Top View ) (OE) pin. The device is designed for operation with a power supply range of 1.65V to 5.5V. The inputs are tolerant to 5.5V, allowing this OE 1 5 Vcc device to be used in a mixed-voltage environment. The device is fully specified for partial power down applications using I . The I OFF OFF A 2 circuitry disables the output preventing damaging current backflow when the device is powered down. 4 GND 3 Y SOT25 / SOT353 Features Applications Voltage Level Shifting Grade 1 Ambient Temperature Operation: -40C to +125C General Purpose Logic Wide Supply Voltage Range from 1.65V to 5.5V Power Down Signal Isolation 24mA Output Drive at 3.3V Wide Array of Products, such as: CMOS Low Power Consumption Automotive Applications within Grade 1 Temperature Range I Supports Partial-Power-Down Mode Operation OFF Industrial Computing/Controls/Automation Inputs Accept up to 5.5V High Reliability Networking/Communications ESD Protection Tested per AEC-Q100 Industrial/Agricultural Equipment Exceeds 2000V Human Body Model (AEC-Q100-002) Exceeds 1000V Charged Device Model (AEC-Q100-011) Latch-Up Exceeds 100mA (AEC-Q100-004) Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2) Halogen and Antimony Free. Green Device (Note 3) The 74LVC1G126Q is suitable for automotive applications requiring specific change control this part is AEC-Q100 qualified, PPAP capable, and manufactured in IATF 16949 certified facilities. 74LVC1G126Q Pin Descriptions Logic Diagram Pin Name Description OE Output Enable Active HIGH 1 A Data Input OE GND Ground Y Data Output 2 4 V Supply Voltage A Y CC Function Table Inputs Output OE A Y H H H H L L L X Z Absolute Maximum Ratings (Notes 4 & 5) Symbol Description Rating Unit ESD HBM Human Body Model ESD Protection 2 kV ESD CDM Charged Device Model ESD Protection 1 kV V Supply Voltage Range -0.5 to 6.5 V CC Input Voltage Range -0.5 to 6.5 V V I -0.5 to 6.5 V V Voltage Applied to Output in High Impedance or I State O OFF Voltage Applied to Output in High or Low State V V -0.5 to V +0.5 O CC I Input Clamp Current V < 0 -50 mA IK I I Output Clamp Current -50 mA OK I Continuous Output Current 50 mA O I , I Continuous Current Through V or GND 100 mA CC GN CC T Operating Junction Temperature -40 to +150 C J T Storage Temperature -65 to +150 C STG Notes: 4. Stresses beyond the absolute maximum can result in immediate failure or reduced reliability. These are stress values and device operation should be within recommend values. 5. Forcing the maximum allowed voltage could cause a condition exceeding the maximum current or conversely forcing the maximum current could cause a condition exceeding the maximum voltage. The ratings of both current and voltage must be maintained within the controlled range. 2 of 10 June 2021 74LVC1G126Q Diodes Incorporated www.diodes.com Document number: DS39798 Rev. 3 - 2