Issue 6.2012 THE SERIALS DOTMATRIX DISPLAYS WITH RS-232 EA SER162-92NLED with snap in housing Accessories: cable EA KV24-9B length: 1,50 m FEATURES * 32 DIFFERENT SIZES OF DISPLAYS AVAILABLE (1x8 UP TO 16x40) 1) * SUPPLY VOLTAGE +5V OR OPTIONAL 9..35V * INCL. LED-ILLUMINATION SWITCHABLE BY MEANS OF SOFTWARE * 25 DISPLAYS WITH YELLOW/GREEN LED-BACKLIGHT * 7 DISPLAYS WITH LOW POWER WHITE LED-BACKLIGHT * 3 DISPLAYS WITH SNAP IN HOUSING * HIGH CONTRAST SUPERTWIST LCD 2) * INCL. FRONTAL BEZEL WITH ANTIGLARE GLASS * AUTOMATIC LINE MANAGEMENT * CR / LF / SCROLL / CURSOR POSITIONING * BAUDRATE SETTING BY JUMPER: 300, 1200, 2400 OR 9600 BAUD * POTI FOR CONTRAST ADJUSTMENT ON BOARD * MULTIPLE DISPLAYS ON SINGLE RS-232C OPTIONS 1) * SUPPLY +9..35V= INSTEAD OF +5V= EA OPT-9/35V 1) * RS-422 INTERFACE INSTEAD OF RS-232 (STANDARD) EA OPT-RS422 1) * DIP-SWITCH FOR ADDRESS INSTEAD OF SOLDERBRIDGE EA OPT-DIP6 ACCESSORIES * CABLE WITH 9-PIN D-SUB FEMALE PLUG FOR PC EA KV24-9B 1) not available with SER308, SER408, SER3016 and SER4016 2) not available with SER082-C, SER204-4, SER242-B, SER3016 and SER4016 Zeppelinstr. 19 D-82205 Gilching Phone +49-8105-778090 Fax +49-8105-778099 www.lcd-module.de info lcd-module.de The SerialsELECTRONIC ASSEMBLY reserves the right to change specifications THE SERIALS without prior notice. Printing and Page 2 typographical errors reserved. General The SerialsThe SerialsThe SerialsThe SerialsThe Serials represents a complete LCD-Dotmatrix familiy with input circuit and frontal bezel. These LCD-modules also includes a RS-232 interface (or optional RS-422). The mounting is done through holes of the LCD-module, the data connection is made to a standard RS-232C/RS-422 interface. Transfer rate can be set by jumper on 300, 1200, 2400 or 9600 Baud. All cursor controls (line feed etc.) are performed automatically. All displays scheme feature LED-backlight illumination. Matching frontal bezel with antiglare glass is included also. Power SUPPLY / CONTRAST ADJUSTMENT Supply voltage is +5V, current consumption depends on type of display and its illumination (100-800 mA, see table on page 20). The Serials can be connected to power either by screw terminals or with RS-232 connector. Display contrast is adjustable by potentiometer. important: It is imperative that the polarity is correct. Even very brief polarity reversal can damage the entire operating unit immediately and irreparably. 9..35V Versorgung bei Displays im Snap-In Multiple Displays on a single RS-232C A single RS-232C can operate a number of displays. For that an individual adress must be assigned to each display. CommandsSelect/Deselec will target each individual display. Adresseinstellung per Ltbrcken Adresseinstellung ber DIP-Schalter Adresseinstellung bei Displays im Snap-In 1) not available with SER308, SER408, SER3016 and SER4016 2) not available with SER082-C, SER204-4, SER242-B, SER3016 and SER4016