50 & 30 W Class 2/Class II CC LED Driver w/ DALI Dimming Max. Nominal Input Max. Case Dimming Dimming Output Efficiency THD Power Factor Voltage Temperature Method Range Power 90C < 20% > 0.9 up to 90% 1 - 100% 120 to 277 Vac 50 W (measured at (from 100% to (from 100% to DALI typical (% of Iout) the hot spot) 50% of load 50% of load) DALI DALI Network DAL + LEDs Series Models with Terminal Blocks, -LEDs Aluminum Case: L 132.2 x W 30.6 x H 20.7 mm (L 5.21 x W 1.20 x H 0.81 in) FEATURES Universal input voltage range Ripple < 10% 20% & 100% load Turn-on: 1% Iout EMI: Compliant with FCC CFR Title 47 Part 15 Class B at 120 Vac & Class A at 277 Vac and with CE EN55015 (CISPR 15) at 220, 230, and 240 Vac Safety, Compliance UL: Class 2 output, Class P Grey: DALI CB, CE FCC, ENEC Blue: Neutral Grey: DALI DAL DALI2, Device Type 6 (parts 101, 102, 207) Series Red: + LEDs Standby power < 0.5 W 120, 240 Vac Black: - LEDs IP20-rated case with silicone-based potting Brown: Line Lifetime: 50,000 hours min at 75 case temperature Wiring Diagram Class II power supply 90 maximum case hot spot temperature NFC PROGRAMMING Current: 100% to 50% in each voltage range Data log read: SKU, S/N, lot code, hours of operation, FW rev., power cycles 5 DAL Series Data Sheet 1 ERP Power, LLC Rev. April 2021 50 & 30 W Class 2/Class II CC LED Driver w/ DALI Dimming 1 - ORDERING INFORMATION Nominal Max Default Open Loop Vout Vout Vout Input Output Iout Programmed (No Load) Part Number Min. Nom. Max. Comments Voltage Power (mA) Current Voltage (Vdc) (Vdc) (Vdc)* (Vac) (W) (mA) (Vdc) DAL30W DAL30W-0600-42-T 120 to 277 25.2 300 to 600 300 28 37.8 42 50 DALI only, Terminal Blocks DAL50W DAL50W-0850-56-T 120 to 277 47.6 425 to 850 425 38 50.4 56 60 DALI only, Terminal Blocks DAL50W-1200-42-T 120 to 277 50.4 600 to 1200 600 28 37.8 42 50 DALI only, Terminal Blocks * The forward voltage (Vf) of the LED load should not exceed Vout Max. of the driver under worst case field operating conditions which are the Vf max. of the LED load under lowest temperature and highest forward current conditions. As a general design guideline, the nominal LED load Vf measured at the operating current and at room temperature should be Vout Nom. of the driver. Programming Wand Part number: NFC WAND Notes: 1. For additional options of output current and output voltage, contact your sales representative or send an email to: SaveEnergy erp-power.com 2. Please order the programming wand using the part number NFC WAND. SaveEnergy erp-power.com 2 www.erp-power.com