PTB30/15 Series 30 W Programmable CC Class 2 LED Driver with Enhanced Tri-Mode Dimming (TRIAC, ELV & 0-10 V) Max. Nominal Input Max. Case Power Dimming Startup Output Efficiency THD Dimming Method Voltage Temperature Factor Range Time Power Programmable Forward-Phase, up to 90% 90C (measured 1 - 100% 300 ms 120 & 277 Vac 30 W < 20% > 0.9 Reverse-Phase typical at the hot spot) (% of Iout) typical & 0 - 10 V TRIAC/ELV Dimmer + Dim 0-10 V -Dim Dimmer PTB30 + LEDs Series -LEDs FEATURES Class 2 power supply Lifetime: 5 years Tc = xxC Side Leads 90C maximum case hot spot temperature L 70 * W 40 * H 29.5 mm IP20-rated case (L 2.76 * W 1.57 * H 1.16 in.) Surge protection: IEC61000-4-5: 2 kV line to line/2 kV line to earth 2.5 kV ring wave: ANSI/IEEE c62.41.1-2002 & c62.41.2-2002 category A Complies with ENERGY STAR, DLC (DesignLight Consortium) and CA Title 24 technical requirements Purple: + Dim Optional mounting clips for multiple mounting methods Neutral: Grey: - Dim White: 120 Vac PTB30 Series Red: + LEDs Line: Blue: - LEDs Black: 120 Vac PROGRAMMING Audio jack programming Wiring Diagram Current: 100% to 60% in each voltage range 0-10 V dimming profiles: Linear, Non-linear, Logarithmic Programmable conduction angles with turn-on & turn-off for TRIAC & ELV APPLICATIONS Data log read: SKU, S/N, lot code, hours of operation, Commercial & residential lighting FW rev., power cycles Architectural lighting Indoor Lighting CA Title 24 PTB30 Series Preliminary Data Sheet 1 ERP Power, LLC Rev. September 2020 Preliminary InformationPTB30/15 Series 30 W Programmable CC Class 2 LED Driver with Enhanced Tri-Mode Dimming (TRIAC, ELV & 0-10 V) 1 - ORDERING INFORMATION Nominal Max Default Open Loop Vout Vout Vout Input Output Iout Programmed (No Load) Part Number Min. Nom. Max. Voltage Power (mA) Current Voltage (Vdc) (Vdc) (Vdc) (Vac) (W) (mA) (Vdc) 120 & 277 VAC NOMINAL INPUT VOLTAGE PTB15W-0350-42 120 & 277 14.7 210 to 350 250 28 37.8 42 50 PTB30W-0500-42 120 & 277 21.0 300 to 500 350 28 37.8 42 50 PTB30W-0700-42 120 & 277 29.4 420 to 700 500 28 37.8 42 50 Notes: By default, each PTB series driver is shipped with 2 metal mounting clips. Additional mounting clips can be ordered separately using the part number PTB-CLIPS-100 or PTB-CLIPS-1K For additional options of output current and output voltage, contact your sales representative or send an email to: SaveEnergy erp-power.com Please order the programming cable using the part number PROG-JACK-USB. Programming Cable Part number: PROG-JACK-USB SaveEnergy erp-power.com 2 www.erp-power.com Preliminary Information