FUJITSU SEMICONDUCTOR DATA SHEET DS501-00016-2v0-E Memory FRAM 2 4 K (512 8) Bit I C MB85RC04V DESCRIPTION The MB85RC04V is an FRAM (Ferroelectric Random Access Memory) chip in a configuration of 512 words 8 bits, using the ferroelectric process and silicon gate CMOS process technologies for forming the nonvolatile memory cells. Unlike SRAM, the MB85RC04V is able to retain data without using a data backup battery. The read/write endurance of the nonvolatile memory cells used for the MB85RC04V has improved to be at 12 least 10 cycles, significantly outperforming other nonvolatile memory products in the number. The MB85RC04V does not need a polling sequence after writing to the memory such as the case of Flash 2 memory or E PROM. FEATURES Bit configuration : 512 words 8 bits Two-wire serial interface : Fully controllable by two ports: serial clock (SCL) and serial data (SDA). Operating frequency : 1 MHz (Max) 12 Read/write endurance : 10 times / byte Data retention : 10 years ( + 85 C), 95 years ( + 55 C), over 200 years ( + 35 C) Operating power supply voltage : 3.0 V to 5.5 V Low-power consumption : Operating power supply current 90 A (Typ 1 MHz) Standby current 5 A (Typ) Operation ambient temperature range : 40 C to + 85 C Package : 8-pin plastic SOP (FPT-8P-M02) RoHS compliant Copyright2012-2013 FUJITSU SEMICONDUCTOR LIMITED All rights reserved 2013.2MB85RC04V PIN ASSIGNMENT (TOP VIEW) NC 1 8 VDD 2 7 A1 WP A2 3 6 SCL VSS 4 5 SDA (FPT-8P-M02) PIN FUNCTIONAL DESCRIPTIONS Pin Pin Name Functional Description Number No Connect pin 1NC Leave this pin open, or connect to VDD or VSS. Device Address pins The MB85RC04V can be connected to the same data bus up to 4 devices. Device addresses are used in order to identify each of these devices. Connect 2, 3 A1, A2 these pins to VDD pin or VSS pin externally. Only if the combination of VDD and VSS pins matches Device Address Code inputted from the SDA pin, the device operates. In the open pin state, A1 and A2 pins are internally pulled-down and recognized as the level. 4 VSS Ground pin Serial Data I/O pin This is an I/O pin which performs bidirectional communication for both memory 5SDA address and writing/reading data. It is possible to connect multiple devices. It is an open drain output, so a pull-up resistor is required to be connected to the ex- ternal circuit. Serial Clock pin 6SCL This is a clock input pin for input/output timing serial data. Data is sampled on the rising edge of the clock and output on the falling edge. Write Protect pin When the Write Protect pin is the H level, the writing operation is disabled. When the Write Protect pin is the L level, the entire memory region can be 7WP overwritten. The reading operation is always enabled regardless of the Write Protect pin input level. The write protect pin is internally pulled down to VSS pin, and that is recognized as the L level (write enabled) when the pin is the open state. 8 VDD Supply Voltage pin 2 DS501-00016-2v0-E