Technical Data Sheet BERGQUIST SILPAD TSP K1100 Known as BERGQUIST SIL-PADK-6 November -2018 PRODUCT DESCRIPTION CONFIGURATIONS AVAILABLE The Economical, HighPerformance Kapton Based Insulator . BERGQUIST SILPAD TSP K1100 are supplied in: Special Thicknesses Technology Silicone Available in a variety ofthicknesses to meet customer Appearance Blue-green requirements. Reinforcement Carrier Kapton Total Thickness 0.15 0.025 Tolerances ,ASTM D374 mm .015 inches are heldon width, length, holediameter and holelocation. Application Thermal management, Thermally conductive adhesive Contact the factory iftighter tolerances are required. Operating Temperature -60 to 180C Sheet form Range 6 x 6 ,6 x 12 ,8 x 8 ,10 x 10 ,or 12 x 12 BERGQUIST SILPAD TSP K1100 is a medium performance Sheets are available from stock, with or without adhesive. Kapton based thermally conductive insulator . Rollform Thermally conductive Kapton MT film is coated with an Sil-Padmaterials are available in rollform, with or without aluminum oxide/boron nitride filledsilicone elastomer to deliver adhesive. Contact the factory.boron nitridperformance .Kapton filmprovides a continuous physically tough dielectric barrier againstcut-throug and Special Shapes resultant assembly failures . We produce thousands ofspecials. Toolingcharges vary TYPICAL PROPERTIES depending on tolerances and complexity ofthe part. Physical Properties Hardness, Shore A,ASTM D2240 90 Conversions Breaking Strength ,ASTM D1458 ,KN/m 5 (C x 1.8)+ 32 = F kV/mm x 25.4 = V/mil Elongation ,45 to warp and fill,ASTM D412,% 40 mm /25.4 = inches Tensile Strength ,ASTM D412,MPa 35 N x 0.225 = lb N/mm x 5.71= lb/in Electrical Properties psi x 145 = N/mm Dielectric Breakdown Voltage ,ASTM D149 (VAC, 6,000 MPa = N/mm min) Nm x 8.851 = lbin Dielectric Constant ,ASTM D150 1,000 Hz 4 Nm x 0.738= lbft 12 Volume Resistivity ,ASTM D257,ohm-meter 110 Nmm x 0.142= ozin mPas = cP Thermal Properties Thermal Conductivity ,ASTM D5470,W/(m-K) 1.1 Disclaimer Thermal Resistance Bergquist Flat Plate Test 0.3 Note: 2 The information provided in this Technical Data Sheet (TDS) including the Method ,C-in /W recommendations for use and application ofthe product are based on our knowledge and experience ofthe product as at the date ofthis TDS. The product can have a variety ofdifferent applications as well as differingapplication and working conditions in your environment that are beyond our control. Henkel is, GENERAL INFORMATION therefore, not liablefor the suitability ofour product for the production processes For safe handling information on this product, consult the Safety and conditions in respect ofwhich you use them, as well as the intended Data Sheet, (SDS). applications and results. We strongly recommend that you carry out your own prior trials to confirm such suitability ofour product. Any liabilityin respect ofthe information in the Technical Data Sheet or any other Not for product specifications written or oral recommendation(s) regarding the concerned product is excluded, The technical data contained herein are intended as reference except ifotherwise explicitly agreed and except in relation to death or personal only. Please contact your local quality department for injury caused by our negligence and any liabilityunder any applicable mandatory assistance and recommendations on specifications for this product liabilitylaw. In case products are delivered by Henkel Belgium NV, Henkel Electronic product. Materials NV, Henkel Nederland BV, Henkel Technologies France SAS and Henkel France SA please additionally note the following: TDS BERGQUIST SILPAD TSP K1100, November -2018 In case Henkel would be nevertheless held liable,on whatever legalground, Henkels liabilitywillin no event exceed the amount ofthe concerned delivery. In case products are delivered by Henkel Colombiana, S.A.S.the following disclaimer is applicable: The information provided in this Technical Data Sheet (TDS) including the recommendations for use and application ofthe product are based on our knowledge and experience ofthe product as at the date ofthis TDS. Henkel is, therefore, not liablefor the suitability ofour product for the production processes and conditions in respect ofwhich you use them, as well as the intended applications and results. We strongly recommend that you carry out your own prior trials to confirm such suitability ofour product. Any liabilityin respect ofthe information in the Technical Data Sheet or any other written or oral recommendation(s) regarding the concerned product is excluded, except ifotherwise explicitly agreed and except in relation to death or personal injury caused by our negligence and any liabilityunder any applicable mandatory product liabilitylaw. In case products are delivered by Henkel Corporation, Resin Technology Group, Inc., or Henkel Canada Corporation, the following disclaimer is applicable: The data contained herein are furnished for information only and are believed to be reliable.We cannot assume responsibility for the results obtained by others over whose methods we have no control. It is the user s responsibility to determine suitability for the user s purpose ofany production methods mentioned herein and to adopt such precautions as may be advisable for the protection of property and ofpersons against any hazards that may be involved in the handling and use thereof. In light ofthe foregoing, Henkel Corporation specifically disclaims all warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose, arising from sale or use of Henkel Corporations products. Henkel Corporation specifically disclaims any liability for consequential or incidental damages of any kind, including lost profits. The discussion herein of various processes or compositions is not to be interpreted as representation that they are free from domination ofpatents owned by others or as a license under any Henkel Corporation patents that may cover such processes or compositions. We recommend that each prospective user test his proposed application before repetitive use, using this data as a guide. This product may be covered by one or more United States or foreign patents or patent applications. Trademark usage: Except as otherwise noted Alltrademarks in this document are trademarks and/or registered trademarks of Henkel and its affiliatesin the U.S. and elsewhere. Reference 1 Americas Europe Asia +1.888.943.6535 +32.1457.5611 +86.21.3898.4800 For the most direct access to local sales and technical support visit: www.henkel.com/electronics