SDP8304-301 Honeywell

SDP8304/8314 Optoschmitt Detector Open-Collector Output FEATURES Side-looking plastic package 55 (nominal) acceptance angle TTL/LSTTL/CMOS compatible Open collector output Buffer (SDP8304) or inverting (SDP8314) logic available High noise immunity output Mechanically and spectrally matched to SEP8506 and SEP8706 infrared emitting diodes INFRA--8.TIF DESCRIPTION OUTLINE DIMENSIONS in inches (mm) The SDP8304/8314 series consists of a high speed IC Tolerance 3 plc decimals 0.005(0.12) molded in a side-looking black plastic package to 2 plc decimals 0.020(0.51) minimize the effect of visible ambient light. The detector incorporates a Schmitt trigger which provides pulse .175 .060 shaping and hysteresis for noise immunity. Output rise (4.45) (1.52) and fall times are independent of rate of change of .060 .030 incident light. Detector sensitivity has been internally (1.52) (0.76) temperature compensated. The output stage is an open collector NPN transistor. This configuration allows the .225 .045 sensor to interface with circuit elements driven by (5.72) (1.14) supply voltages other than the V supply. For additional output configuration options refer to .020 SQ. 3 PLCS (0.51) .500 SDP8004/8014 and SDP8604/8614045(1.14) MIN ~ ~ ~ ~ (12.71) .025(.64) GND Vo Vcc ~ ~ ~ ~ Device Polarity: Buffer - Output is HI when incident light intensity is .075 above the turnon threshold level. (1.91) 0.150 Inverter - Output is LO when incident light intensity is (3.81) above the turnon threshold level. DIM 026.ds4 Honeywell reserves the right to make changes in order to improve design and 188 h supply the best products possible.SDP8304/8314 Optoschmitt Detector Open-Collector Output ELECTRICAL CHARACTERISTICS PARAMETER SYMBOL MIN TYP MAX UNITS TEST CONDITIONS ABSOLUTE MAXIMUM RATINGS SCHEMATIC (25C Free-Air Temperature unless otherwise noted) Supply Voltage 12 V Duration of Output Short to V or Ground 1.0 sec Applied Output Voltage 35 V Low Level Output Current 16 mA Irradiance 25 mW/cm Operating Temperature Range -40C to 85C Storage Temperature Range -40C to 85C Soldering Temperature (5 sec) 240C Notes 1. Derate linearly from 25C to 5.5 V at 85C. Honeywell reserves the right to make changes in order to improve design and 189 h supply the best products possible.