IS25LP128 IS25LP064 IS25LP032 32/64/128M-BIT 3V SERIAL FLASH MEMORY WITH 133MHZ MULTI I/O SPI & QUAD I/O QPI DTR INTERFACE DATA SHEET IS25LP032/064/128 32/64/128M-BIT 3V SERIAL FLASH MEMORY WITH 133MHZ MULTI I/O SPI & QUAD I/O QPI DTR INTERFACE FEATURES Industry Standard Serial Interface - IS25LP128: 128M-bit/16M-byte Low Power with Wide Temp. - IS25LP064: 64M-bit/8M-byte Ranges - IS25LP032: 32M-bit/4M-byte - Single 2.3V to 3.6V Voltage Supply - 256 bytes per Programmable Page - 10 mA Active Read Current - Supports standard SPI, Fast, Dual, Dual - 10 A Standby Current I/O, QPI, SPI DTR, Dual SPI DTR I/O, - 5 A Deep Power Down and QPI - Temp Grades: - Double Transfer Rate (DTR) option Extended: -40C to +105C - Supports Serial Flash Discoverable V Grade: -40C to +125C Auto Grade: up to +125C Parameters (SFDP) Advanced Security Protection High Performance Serial Flash (SPI) - Software and Hardware Write Protection - 50MHz Normal and 133Mhz Fast Read - Power Supply lock protect - 532 MHz equivalent QPI - 4x256-Byte dedicated security area - DTR (Dual Transfer Rate) up to 66MHz with user-lockable bits, (OTP) One - Selectable dummy cycles Time Programmable Memory - Configurable drive strength - 128 bit Unique ID for each device - Supports SPI Modes 0 and 3 - More than 100,000 erase/program cycles - More than 20-year data retention Industry Standard Pin-out & Packages - JM =16-pin SOIC 300mil - JB = 8-pin SOIC 208mil Flexible & Efficient Memory Architecture - JF = 8-pin VSOP 208mil - Chip Erase with Uniform: Sector/Block - JK = 8-contact WSON 6x5mm Erase (4K/32K/64K-Byte) - JL = 8-contact WSON 8x6mm - Program 1 to 256 bytes per page - JG= 24-ball TFBGA 6x8mm - Program/Erase Suspend & Resume - KGD (call factory) Efficient Read and Program modes - Low Instruction Overhead Operations - Continuous Read 8/16/32/64-Byte burst - Selectable burst length - QPI for reduced instruction overhead Integrated Silicon Solution, Inc.- www.issi.com 2 Rev. D 10/03/2014