Cover headline Cover headline SURE-SEAL SeriesSURE-SEAL Reliability. Low Cost. Performance. Delivery. SURE-SEAL connectors a series of low cost and environmentally sealed SURE-SEAL connectors were designed to meet the increased connectors. requirements for safety and reliability in the automotive field brought about by Department of Transportation regulations. These sealed The one-piece molded body and rugged multiple moisture seals make connectors satisfy all of the parameters defined by automotive / the SURE-SEAL connector a natural for applications whose outside industrial standards including vibration, shock, temperature cycling, salt contaminants must be excluded. water spray and immersion, petroleum derivatives, industrial gas, and most important low millivolt drop and low contact resistance. One of the many features of the SURE-SEAL connector is its simplicity. In addition to the contacts, only two other parts the connector bodies are required to complete the interconnect. Features Polarized Against Mis-Mates Low Installed Cost SURE-SEAL connector mating faces are constructed with two stepped planes SURE-SEAL connectors are designed to be terminated by the O.E.M. the plug and receptacle must be properly oriented in order for the contacts to engage. For blind mating a raised indexing rib and matching raised Field Service indexing spline has been added to the plug and receptacle. When necessary, SURE-SEAL connectors can be changed, modified or wired in the field. Water Submersible Not just splash proof, but truly submersible for short periods of time. One-Piece Molded Bodies SURE-SEAL fulfills the requirements according to IP68, IEC 60529. Note: The SURE-SEAL connector incorporates a very simple one-piece Although SURE-SEAL can withstand submersion, it is not designed to be an molded body. No other parts other than contacts are needed to underwater connector. assemble a complete connector. Resistant to Automotive/Commercial Environment Low Cost Stamped Contacts SURE-SEAL connectors are designed to meet temperatures from 40C to Without sacrificing quality, the cost of SURE-SEAL connectors is kept 105C under conditions of high humidity severe vibration, ice and mud. low with stamped contacts available on reels in a continuous strip for Sealing integrity is still maintained with exposure to brake fluid, gasoline, use on the industry accepted semi automatic crimp press with mini diesel fuel, anti-freeze, ultra violet, ozone, steam cleaning under normal applicator. All contacts utilize a B type crimp. operating conditions. Wide Wire Gage and Cable Accommodations 2 Environment & Health Ideally suited to be terminated on wires of size 0,4-1,5 mm (AWG RoHS compliant 14-20), wire sizes with insulation in the range of 1,4-1,8 for Mini Sure Seal, resp. 1,8 - 2,8 for Sure Seal, termination to multiconductor jacketed cables in the range of 5,3 to 12,4 mm diameter and can be terminated to five different wire ranges depending on contact arrangements with total environment sealing still assured. Sealing Locking Locking lips ring Design groove Locking Boot Socket Sealing lips Pin groove Boot contact contact Pin Sealing Polarization contact Guide lips Wire hole Polarization edge Socket Sealing fillers Guide contact lips edge The ITT Engineered Blocks symbol and the composite ITT logo are registered trademarks of ITT Corporation. 2016. Dimensions shown in mm Specifications and dimensions subject to change www.ittcannon.com 2