AA2735SRSGS Kingbright

2.7x3.5mm SURFACE MOUNT LED LAMP Part Number: AA2735SRSGS Super Bright Red Super Bright Green Features Description z 2.7mm X 3.5mm SMT LED, 1.5mm height only. The Super Bright Red source color devices are made with z Both chips can be controlled separately. Gallium Aluminum Arsenide Red Light Emitting Diode. z Suitable for all SMT assembly and solder process. The Super Bright Green source color devices are made with z Available on tape and reel. Gallium Phosphide Green Light Emitting Diode. z Ideal for backlighting. z Package: 1000pcs / reel. z Moisture sensitivity level : level 3. z RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. 5. The device has a single mounting surface. The device must be mounted according to the specifications. SPEC NO: DSAM0513 REV NO: V.1 DATE: AUG/24/2011 PAGE: 1 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: D.M.Su ERP: 1201006880 Handling Precautions Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible. Although its characteristic significantly reduces thermal stress, it is more susceptible to damage by external mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated LED products. Failure to comply might lead to damage and premature failure of the LED. 1. Handle the component along the side surfaces by using forceps or appropriate tools. 2. Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry. 3. Do not stack together assembled PCBs containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry. 4.1. The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks. 4.2. A pliable material is suggested for the nozzle tip to avoid scratching or damaging the LED surface during pickup. 4.3. The dimensions of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production. 5. As silicone encapsulation is permeable to gases, some corrosive substances such as H S might corrode silver plating of 2 leadframe. Special care should be taken if an LED with silicone encapsulation is to be used near such substances. SPEC NO: DSAM0513 REV NO: V.1 DATE: AUG/24/2011 PAGE: 2 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: D.M.Su ERP: 1201006880