3.5x3.5 mm SMD CHIP LED LAMP Part Number: KA-3535SELZ4S Hyper Orange ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Description The Hyper Orange device is made with TS AlGaInP light Features emitting diode. z White SMD package, silicone resin. Static electricity and surge damage the LEDS. z Low thermal resistance. It is recommended to use a wrist band or anti-electrostatic z Compatible with IR-reflow processes. glove when handling the LEDs. z ESD protection. All devices, equipment and machinery must be electrically z Package: 2000pcs / reel. grounded. z Moisture sensitivity level : level 2a. z RoHS compliant. Applications z Signal and symbol luminaire for orientation. z Marker lights (e.g. steps, exit ways, etc). z Decorative and entertainment lighting. z Commercial and residential lighting. z Automotive interior lighting. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. 4. The device has a single mounting surface. The device must be mounted according to the specifications. SPEC NO: DSAM0798 REV NO: V.4B DATE: MAR/29/2013 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: F.Cui ERP: 1201007945 KingbrightHandling Precautions Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible. Although its characteristic significantly reduces thermal stress, it is more susceptible to damage by external mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated LED products. Failure to comply might lead to damage and premature failure of the LED. 1. Handle the component along the side surfaces by using forceps or appropriate tools. 2. Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry. 3. Do not stack together assembled PCBs containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry. 4.1. The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks. 4.2. A pliable material is suggested for the nozzle tip to avoid scratching or damaging the LED surface during pickup. 4.3. The dimensions of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production. 5. As silicone encapsulation is permeable to gases, some corrosive substances such as H S might corrode silver plating of 2 leadframe. Special care should be taken if an LED with silicone encapsulation is to be used near such substances. Detailed application notes are listed on our website.