KAF-5060VBDSEEVGAS Kingbright

5.0mm x 6.0mm FULL COLOR LED LAMP Part Number: KAF-5060VBDSEEVGAS ATTENTION Blue OBSERVE PRECAUTIONS Hyper Red FOR HANDLING Green ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Description z Outstanding material efficiency. The Blue source color devices are made with InGaN Light z Reliable and rugged. Emitting Diode. z Low power consumption. The Hyper Red source color devices are made with Al- z Can produce any color in visible spectrum, including white light. GaInP on GaAs substrate Light Emitting Diode. z Moisture sensitivity level : level 3. The Green source color devices are made with InGaN on G- z RoHS compliant. SiC Light Emitting Diode. Static electricity and surge damage the LEDS. It is recommended to use a wrist band or anti-electrostatic glove when handling the LEDs. All devices, equipment and machinery must be electrically grounded. Package Dimensions BLUE RED GREEN Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAM9368 REV NO: V.1A DATE: MAR/27/2013 PAGE: 1 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: F.Cui Handling Precautions Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible. Although its characteristic significantly reduces thermal stress, it is more susceptible to damage by external mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated LED products. Failure to comply might lead to damage and premature failure of the LED. 1. Handle the component along the side surfaces by using forceps or appropriate tools. 2. Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry. 3. Do not stack together assembled PCBs containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry. 4.1. The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks. 4.2. A pliable material is suggested for the nozzle tip to avoid scratching or damaging the LED surface during pickup. 4.3. The dimensions of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production. 5. As silicone encapsulation is permeable to gases, some corrosive substances such as H S might corrode silver plating of 2 leadframe. Special care should be taken if an LED with silicone encapsulation is to be used near such substances. Detailed application notes are listed on our website.