KCDA03-123 Kingbright

SURFACE MOUNT DISPLAY Part Number: KCDA03-123 Green Features Description z 0.3 inch digit height. The Green source color devices are made with AlGaInP on z Low current operation. GaAs substrate Light Emitting Diode. z Excellent character appearance. z Mechanically rugged. z Package :300pcs / reel. z Gray face, white segment. z Moisture sensitivity level : level 2a. z RoHS compliant. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01 )unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. 3.The gap between the reflector and PCB shall not exceed 0.25mm. SPEC NO: DSAG7167 REV NO: V.11A DATE: JUN/18/2016 PAGE: 1 OF 5 APPROVED: Wynec CHECKED: Joe Lee DRAWN: L.T.Zhang ERP: 1352000345 KingbrightSelection Guide Iv (ucd) 1 10mA Part No. Emitting Color (Material) Lens Type Description Min. Typ. 3600 12000 Common Anode, Rt. KCDA03-123 Green (AlGaInP) White Diffused Hand Decimal. *1400 *3100 Note: 1.Luminous intensity/ luminous Flux: +/-15%. *Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Emitting Color Typ. Max. Units Test Conditions peak Peak Wavelength Green 574 nm IF=10mA D 1 Dominant Wavelength Green 570 nm IF=10mA 1/2 Spectral Line Half-width Green 20 nm IF=10mA C Capacitance Green 15 pF VF=0V f=1MHz VF 2 Forward Voltage Green 2.0 2.5 V IF=10mA IR Reverse Current Green 10 uA VR=5V Notes: 1.Wavelength: +/-1nm. 2.Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to CIE127-2007 standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Values Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current 1 150 mA Reverse Voltage 5 V Operating / Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAG7167 REV NO: V.11A DATE: JUN/18/2016 PAGE: 2 OF 5 APPROVED: Wynec CHECKED: Joe Lee DRAWN: L.T.Zhang ERP: 1352000345 Kingbright