L-36BID Kingbright

T-1 (3mm) BLINKING LED LAMP Part Number: L-36BID High Efficiency Red ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Descriptions T-1 package with rectangular base. The High Efficiency Red source color devices are made With built-in blinking IC. with Gallium Arsenide Phosphide on Gallium Phosphide Operation voltage from 3.5V to 14V. Orange Light Emitting Diode. Blinking frequency from 3.0Hz to 1.5Hz. Electrostatic discharge and power surge could damage RoHS compliant. the LEDs. It is recommended to use a wrist band or anti- electrostatic glove when handling the LEDs. All devices, equipments and machineries must be electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAB7626 REV NO: V.10A DATE: NOV/13/2014 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101003774 KingbrightSelection Guide Iv (mcd) Viewing V= 9V Angle 1 Part No. Dice Lens Type Min. Typ. 21/2 12 25 L-36BID High Efficiency Red (GaAsP/GaP) Red Diffused 60 *6 *15 Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. *Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Min. Typ. Max. Units Test Conditions peak Peak Wavelength High Efficiency Red 627 nm D Dominant Wavelength High Efficiency Red 617 nm 1/2 Spectral Line Half-width High Efficiency Red 45 nm Min:VF=3.5V IF Forward Current High Efficiency Red 8 22 mA Typ:VF=5V ISON Supply Current High Efficiency Red 8 mA VF=3.5V ISON Supply Current High Efficiency Red 44 mA VF=14V f Blink Frequency High Efficiency Red 1.5 3 Hz VF=3.5V~14V Note: 1.Wavelength value is traceable to the CIE127-2007 compliant national standards. 2.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter High Efficiency Red Units Power dissipation 310 mW Forward Voltage 14 V Reverse Voltage 0.5 V Operating Temperature -40C To +70C Storage Temperature -40C To +85C Lead Solder Temperature 1 260C For 3 Seconds Lead Solder Temperature 2 260C For 5 Seconds Notes: 1. 2mm below package base. 2. 5mm below package base. SPEC NO: DSAB7626 REV NO: V.10A DATE: NOV/13/2014 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101003774 Kingbright