TA07-11SEKWA Kingbright

18mm (0.7 INCH) SINGLE COLOR DOT MATRIX DISPLAY Part Number: TA07-11SEKWA Super Bright Orange Features Description z 0.7 inch matrix height. The Super Bright Orange device is made with AlGaInP (on z Dot size 2mm. GaAs substrate) light emitting diode chip. z Low current operation. z Stackable vertically and horizontally. z Easy mounting on P.C. boards or sockets. z Mechanically rugged. z Standard: gray face, white dot. z RoHS compliant. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01 )unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAE6150 REV NO: V.8A DATE: JUN/29/2016 PAGE: 1 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1332000936 KingbrightSelection Guide Iv (ucd) 1 10mA Part No. Emitting Color (Material) Lens Type Description Min. Typ. 52000 120000 TA07-11SEKWA Super Bright Orange (AlGaInP) White Diffused Column Anode *21000 *42000 Notes: 1. Luminous intensity / luminous Flux: +/-15%. * Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Emitting Color Typ. Max. Units Test Conditions peak Peak Wavelength Super Bright Orange 610 nm IF=10mA D 1 Dominant Wavelength Super Bright Orange 601 nm IF=10mA 1/2 Spectral Line Half-width Super Bright Orange 29 nm IF=10mA C Capacitance Super Bright Orange 15 pF VF=0V f=1MHz VF 2 Forward Voltage Super Bright Orange 2 2.5 V IF=10mA IR Reverse Current Super Bright Orange 10 uA VR=5V Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to CIE127-2007 standards. 4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Values Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current 1 195 mA Reverse Voltage 5 V Operating / Storage Temperature -40C To +85C Lead Solder Temperature 2 260C For 3-5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAE6150 REV NO: V.8A DATE: JUN/29/2016 PAGE: 2 OF 6 APPROVED: Wynec CHECKED: Joe Lee DRAWN: W.Q.Zhong ERP: 1332000936 Kingbright