WP115A10GD Kingbright

T-1 (3mm) SOLID STATE LAMP Part Number: WP115A10GD Green Features Description z Low power consumption. The Green source color devices are made with Gallium z Popular T-1 diameter package. Phosphide Green Light Emitting Diode. z General purpose leads. z Reliable and rugged. z Long life - solid state reliability. z Available on tape and reel. z RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAL9459 REV NO: V.3B DATE: OCT/25/2016 PAGE: 1 OF 6 APPROVED: Wynec CHECKED: Allen Liu DRAWN: W.Q.Zhong ERP: 1101031489 Selection Guide Iv (mcd) 2 Viewing 10mA Angle 1 Part No. Emitting Color (Material) Lens Type Min. Typ. 21/2 WP115A10GD Green (GaP) Green Diffused 10 25 60 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity / luminous Flux: +/-15%. 3. Luminous intensity value is traceable to CIE127-2007 standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Emitting Color Typ. Max. Units Test Conditions peak Peak Wavelength Green 565 nm IF=10mA D 1 Dominant Wavelength Green 568 nm IF=10mA 1/2 Spectral Line Half-width Green 30 nm IF=10mA C Capacitance Green 15 pF VF=0V f=1MHz VF 2 Forward Voltage Green 2 2.5 V IF=10mA IR Reverse Current Green 10 uA VR = 5V Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to CIE127-2007 standards. 4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Values Units Power dissipation 62.5 mW DC Forward Current 25 mA Peak Forward Current 1 140 mA Reverse Voltage 5 V Operating/Storage Temperature -40C To +85C Lead Solder Temperature 2 260C For 3 Seconds Lead Solder Temperature 3 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. 4. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static electricity Ref JEDEC/JESD625-A and JEDEC/J-STD-033. SPEC NO: DSAL9459 REV NO: V.3B DATE: OCT/25/2016 PAGE: 2 OF 6 APPROVED: Wynec CHECKED: Allen Liu DRAWN: W.Q.Zhong ERP: 1101031489