WP132XGC Kingbright

T-1 (3mm) SOLID STATE LAMP Part Number: WP132XGC Green Features Description z Low power consumption. The Green source color devices are made with Gallium z Popular T-1 diameter package. Phosphide Green Light Emitting Diode. z General purpose leads. z Reliable and rugged. z Long life-solid state reliability. z Available on tape and reel. z RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAF1654 REV NO: V.5B DATE: JAN/16/2015 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101001070 Selection Guide Iv (mcd) 2 Viewing 10mA Angle 1 Part No. Dice Lens Type Min. Typ. 21/2 WP132XGC Green (GaP) Water Clear 20 40 50 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. 3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. Units Test Conditions peak Peak Wavelength Green 565 nm IF=20mA D 1 Dominant Wavelength Green 568 nm IF=20mA 1/2 Spectral Line Half-width Green 30 nm IF=20mA C Capacitance Green 15 pF VF=0V f=1MHz VF 2 Forward Voltage Green 2.2 2.5 V IF=20mA IR Reverse Current Green 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2.Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to the CIE127-2007 compliant national standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Green Units Power dissipation 62.5 mW DC Forward Current 25 mA Peak Forward Current 1 140 mA Reverse Voltage 5 V Operating/Storage Temperature -40C To +85C Lead Solder Temperature 2 260C For 3 Seconds Lead Solder Temperature 3 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF1654 REV NO: V.5B DATE: JAN/16/2015 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101001070