WP710A10SET Kingbright

T-1(3mm) SOLID STATE LAMP Part Number: WP710A10SET Super Bright Orange Features Description Low power consumption. The Super Bright Orange device is made with AlGaInP (on Popular T-1 diameter package. GaAs substrate) light emitting diode chip. General purpose leads. Reliable and rugged. Long life - solid state reliability. Available on tape and reel. RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217 Selection Guide Iv (mcd) 2 Viewing 20mA Angle 1 Part No. Dice Lens Type Min. Typ. 21/2 900 1700 WP710A10SET Super Bright Orange (AlGaInP) Orange Transparent 34 *350 *800 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2.Luminous intensity/ luminous Flux: +/-15%. *Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. Units Test Conditions peak Peak Wavelength Super Bright Orange 610 nm IF=20mA D 1 Dominant Wavelength Super Bright Orange 601 nm IF=20mA 1/2 Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 30 pF VF=0V f=1MHz VF 2 Forward Voltage Super Bright Orange 2 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2.Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to the CIE127-2007 compliant national standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Super Bright Orange Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current 1 195 mA Reverse Voltage 5 V Operating/Storage Temperature -40C To +85C Lead Solder Temperature 2 260C For 3 Seconds Lead Solder Temperature 3 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217