POE-48iD Power-Over-Ethernet Midspan POWER OVER ETHERNET MIDSPAN Power Supply / Inserter The POE-48iD is an advanced 802.3af compliant device with Midspan Intelligent Detection. The device does not turn on power until it detects a valid Power-Over-Ethernet (POE) signature from the devices attached downstream on the Ethernet cable. This protects against damage to non- compliant equipment which may be connected to the Ethernet cable. Because of this intelligent detection, only an 802.3af compliant device can be powered with the POE-48iD. Because of its 48 V inserter, the installer doesnt need to worry about voltage drops due to cable length. Typically in 100 MB networks, the maximum allowable CAT5 cable run is about 100 meters. This is not a limitation of the POE equipment, but rather a limitation of the Ethernet standards. The POE-48iD is not a proprietary unit. It will function with any equipment which is fully compliant with the IEEE 802.3af POE standards. Note: The equipment being powered must be fully 802.3af compliant in order for the power supply to be able to sense the devices signature and apply power. Power is supplied on Ethernet pins 4/5 (V+) and 7/8 (GND). Using POE to power remote devices has several advantages including: The power supply can be centrally located, where it can be attached to an uninterruptible power supply. The user has the ability to easily power on reset the attached equipment from a remote location. There is no need to run additional power cabling to the device, as power can be supplied over the CAT5 Ethernet cable. FEATURES AND BENEFITS: APPLICATIONS: Carrier class POE system Remote routers, access points and bridges 48 VDC auto ranging power supply / inserter Remote networking equipment SOHO equipment 802.3af Midspan Intelligent Detection - extra safety IP camera systems Built-in Ethernet surge protection to prevent equipment damage 400 MHz to 10 GHz systems Overload and short circuit protection IP phone systems Minimum cross-talk and insertion loss WiMAX Advanced switching technology runs cool Powers clients which accept power on unused Ethernet pins 4, 5, 7, 8 FCC and CE approved Current indicator (CI) option available Americas: +1.847 839.6907 IAS-AmericasEastSales lairdtech.com Europe: +44.1628.858941 IAS-EUSales lairdtech.com Asia: +86.21.5855.0827.127 IAS-AsiaSales lairdtech.com www.lairdtech.com POE-48iD Power-Over-Ethernet Midspan POE-48ID POWER SUPPLY/INJECTOR Input Voltage 90 264 VAC 47 63 Hz Input Current 0.3 A 120 VAC 0.2 A 230 VAC Inrush Current <15 A peak 120 VAC <30 A peak 230 VAC Efficiency 70% Min. Output Voltage 48 VDC 0.35 A Output Ripple 1% Max Switching Frequency 200 KHz Typ Line Regulation +/- 0.5% Load Regulation +/- 1% Operating Temperature -10 to +60C Storage Temperature -20 to +85C Operating Humidity 5% to 90% non condensing Size (L x W x H) 3.25 x 3 x 1.5 in (83 x 76 x 38 mm) Weight 5.2 oz (147 gm) AC Connector IEC-320 C6 (Supercom SC-14) Data IN Conn. RJ45 Shielded Socket Data/POE OUT Conn. RJ45 Shielded Socket LED RED AC Power / ALARM Orange Channel Power COMPLIANCE: IEEE 802.3af POE Standard Mode B EMI EMI EN55022 ( CISPR22) class B Meets CE EMS EN61000-4-2,3,4,5,6,8,11 SYSTEM ORDERING: POE-48iD 48 VDC POE Power Supply / Inserter module with Midspan 802.3af Intelligent Interface (Includes AC Power Cord) NOTES: All shipments F.O.B. Schaumburg, IL 60173 Power Supply Inserter AC Power IN (90-264 VAC) Power Supply Inserter Data IN Power Supply Inserter Data/POE OUT ANT-DS-POE-48iD 0915 Any information furnished by Laird Inc. and its agents is believed to be accurate and reliable. All specifications are subject to change without notice. 802.3af POE Power Up Sequence Responsibility for the use and application of Laird materials rests with the end user, since Laird and its agents cannot be aware of all potential uses. Laird makes no warranties as to the fitness, merchantability or suitability of any Laird materials or products for any specific or general uses. Laird shall not be 1. Detection Look for 802.3af compliant signature liable for incidental or consequential damages of any kind. All Laird products are sold pursuant to the Laird Terms and Conditions of sale in effect from time to time, a copy of which will be furnished upon request. Copyright 2015 Laird Inc. All Rights Reserved. Laird, Laird Technologies, the Laird Logo, 2. Startup Ramp power safely and other marks are trade marks or registered trade marks of Laird Inc. or an affiliate company thereof. Other product or service names may be the property of third parties. Nothing herein provides a license under any Laird or any third party intellectual property rights. 3. Operation Continuously monitor for short circuit or overload