Commercial Device Servers Replace expensive dedicated PCs with fast and reliable networking technology Compact size enables it to fit almost anywhere Supports RS-232, RS-422 and RS-485 serial connections 10Mbps or 10/100 Mbps Ethernet through an RJ45 connector Configure via HTTP, DHCP, Telnet or serial Flash ROM for easy upgrades Remotely Monitor, Manage and Share Devices Over a Network or the Internet applications. With virtual COM ports, mapped to In todays economy, faster and better access to remote device servers on the network, you can replace information can mean the difference between success direct serial connections. and failure. The UDS-10 and UDS100 single-port device Easy to Set Up and Use servers provide a quick, simple and cost-effective way to The included Windows-based configuration software simplifies installation and setup. The UDS-10 and bring the advantages of data accessibility and remote UDS100 can also be set up locally through the serial management to equipment not currently connected port, or remotely over a network using Telnet or a to a network. web browser. The UDS even includes a built-in web server, which can Our approach to network-enabling devices is be used for configuration, or to display operating and transparent to your attached devices and software. troubleshooting information on the attached links to So, you wont need to change the way you work, online support. and theres no need to develop special software to Flash memory provides for maintenance-free non- take advantage of Ethernet networking. And with the volatile storage of web pages, and allows future UDS-10(10Base-T) and UDS100(100Base-T/100Base-TX) system software upgrades. any piece of equipment with a serial port can be added to the network in a matter of minutes Modem Replacement Using a method called serial tunneling, UDS In modem emulation mode, the UDS-10 and UDS100 encapsulates serial data into packets and transports it can be used to replace dial-up modems. The unit over Ethernet. Using two UDS Device Servers accepts modem AT commands on the serial port, then connected by a network, virtual serial connections can establishes a network connection to the end device, be extended across a facility or around the world. So leveraging network connections and bandwidth to you can manage your equipment from virtually eliminate dedicated modems and phone lines. anywhere over Ethernet or the Internet. If youre looking for a transparent, cost-effective, and The included redirection software extends the scalable means to network-enable your serial devices, functionality of your COM port-based Windows look no further than the UDS-10 and UDS100. Device Server UDS-10/UDS100Example Configurations Features Protocols Supported SERIAL TUNNELING CONFIGURATION ARP, UDP, TCP, Telnet, ICMP, SNMP, DHCP, TFTP, and HTTP Ethernet Device Support Supports any asynchronous serial device with 7 or 8-bit data, with or without parity requiring Ethernet access UDS Device Servers Network Interface RJ45 (10Base-T) Ethernet (UDS-10) RJ45 (10Base-T/100Base-TX) Ethernet (UDS 100) Serial Interface DB25F, RS-232/RS-422/RS-485 serial port with DCE configuration POS Device Data Rates Serial speeds 300 bps to 115 Kbps Personal Computer (PC) Modem Controls RTS, CTS, DSR, DCD, DTR Flow Control Software XON/XOFF Hardware CTS/RTS DIRECT TCP/IP Management OR REDIRECTOR CONFIGURATION Internal HTTP server SNMP (read only) Ethernet Serial login Telnet login Firmware UDS Flash ROM standard downloadable from a TCP/IP host Device Server (TFTP) or over the serial port Indicators (LED) Personal Computer (PC) Good Link (green) Network transmit/Receive data (yellow) Collisions (red) POS Device Diagnostic (red) Status (green) Power Power input via standard barrel connector or DB25 serial connector Input Range: 9 to 30 VDC or 9 to 24 VAC 1W max Ordering Information UDS-10-01 Device Server, 1 DB25 (RS-232/RS-485/ Environmental RS-422) DCE serial port, RJ45 (10Base-T) Operating: 5 to 50 C (41 to 122 F) network ports, diagnostic LEDs, installation Storage: -40 to 66 C (-40 to 151 F) guide, external 110 VAC power supply Physical UDS-10-02 Same as above with 100-240 VAC power Dimensions: 9.0 x 6.4 x 2.3 cm (3.5 x 2.5 x 0.9 in) supply with international adapters Weight: .35 Kg (.8 lb) Shipping Dimensions: 24.2 x 19.1 x 11.5 cm UDS-M-SBC Optional male DB25 to screw terminal block connector (9.5 x 7.5 x 4.5 in), Weight: 1.5 kg (3.0 lb) UDS-100-01 Device Server, 1 DB25 (RS-232, RS-422, RS-485) Agency Approvals DCE serial port, RJ45 (10Base-T/100Base-TX) CE, FCC B, TUV, C/UL network ports, diagnostic LEDs, installation guide, external 110 VAC power supply Warranty 1-year limited warranty UDS-100-02 Same as above with 100-240 VAC power supply with international adapters 15353 Barranca Parkway Irvine CA 92618 USA Tel: 800.422.7055 Fax: 949.450.7232 www.lantronix.com 2006 Lantronix, Inc. Lantronix is a registered trademark, and Device Server is a trademark of Lantronix, Inc. All other trademarks are the property of their respective owners. Specifications subject to change without notice. All rights reserved. 910-316 07/06 DGS2500 Device Server UDS-10/UDS100