XPC240300EK Lantronix

xPico 240 Evaluation Kit Quick Start Guide WHATS IN THE BOX 5V Power Supply with xPico 240 u.fl to RP-SMA Adapter Firmware & Regional Adapters Evaluation Board Cables and Antennas License Agreement 1. HARDWARE OVERVIEW LED 2 Ethernet Speed LED 3 Ethernet Activity xPico 240 Power LED Module LED1 Reset Defaults Wake Status 10/100 Ethernet RJ 45 DB9 RS232 Serial Port 5V DC Power Input Peripheral I/O Header Power USB Port On/Off Host/Device 3.3V Install for USB Host Header 2. HARDWARE INSTALLATION 2a. Attach the antenna(s) to the evaluation board. 2b. Supply power to the evaluation board by plugging in the included power adapter to the 5V DC Power Input (shown above). 2c. Move the ON/OFF power switch to ON. 2d. Proceed to the next page for instructions on how to configure the xPico 240 using the web manager UI. xPico 240 Evaluation Kit Quick Start Guide xPico 240 Quick Start Guide 3. CONNECT TO WEB MANAGEMENT CONSOLE The steps below outline how to access the web management console to begin configuring the xPico 240 gateway. 192.168.0.1 xPico 240 XXX-XXX Network 1 Username Network 2 Password Network 3 Network 4 3a. Connect to the network using the unique xPico 240 SSID. 3b. Connect to 192.168.0.1 using your web browser. The This number refers to the last 6 digits of the serial number default USER ID = admin and PASSWORD = PASSWORD printed on the module. See highlighted section. The default (both case sensitive). password for this Wi-Fi Soft AP is PASSWORD (case sensitive). 4. INITIAL CONFIGURATION 4a. Once logged in, click the Quick Connect menu to 4b. On the Quick Connect Page, the wireless client interface continue with the configuration of the xPico 240 and can be configured. The xPico 240 can now connect to a connect to the Wi-Fi network. network from the list of available wireless networks. 5. COMPLETE THE CONFIGURATION Continue with the rest of the unit configuration using the Web Managment Interface (UI). Context-sensitive help is available in-line within the Web UI. The unit can also be configured using the Command Line Interface (CLI). The CLI is accessible via the serial port. For detailed instructions, please refer to the xPico 200 Series User Guide: docs.lantronix.com/products/xpico-200/ KEEP YOUR DEVICE SECURE. Please change the default Soft AP SSID password and administrator password before proceeding further. From the Network menu in the Web UI, follow this path: ap0 Link Configuration to set the AP password. Click OK to apply these new settings. Next, from the User menu in the Web UI, select admin user and enter a new password. Click OK to apply these new settings. Reboot and continue with the rest of the configuration. TECHNICAL SUPPORT LATEST FIRMWARE For technical support queries, visit