SP211EET-LTR MaxLinear

SP208E / SP211E / SP213E Data Sheet Low Power, High ESD +5V RS-232 Transceivers General Description Features The SP208E-SP213E are enhanced transceivers intended Meets all EIA-232 and ITU V.28 specifications for use in RS-232 and V.28 serial communication. These Single +5V supply operation devices feature very low power consumption and single- 3mA typical static supply current supply operation making them ideal for space-constrained applications. MaxLinear on-board charge pump circuitry 4 x 0.1F external charge pump capacitors generates fully compliant RS-232 voltage levels using small 120kbps transmission rates and inexpensive 0.1F charge pump capacitors. External +12V and -12V supplies are not required. The SP211E and Standard SOIC and SSOP footprints SP213E feature a low-power shutdown mode, which reduces 1A shutdown mode (SP211E & SP213E) power supply drain to 1A. SP213E includes two receivers that remain active during shutdown to monitor for signal Two wake-up receivers (SP213E) activity. Tri-state / Rx enable (SP211E & SP213E) The SP208E-SP213E devices are pin-to-pin compatible with Improved ESD specifications: our previous SP208, SP211 and SP213 as well as industry- 15kV Human Body Model standard competitor devices. Driver output and receiver 15kV IEC6100-4-2 Air Discharge input pins are protected against ESD to over 15kV for both 8kV IEC6100-4-2 Contact Discharge Human Body Model and IEC61000-4-2 Air Discharge test methods. Data rates of 120kbps are guaranteed, making Table 1: Model Selection Table them compatible with high speed modems and PC remote- Device Drivers Receivers Pins access applications. Receivers also incorporate hysteresis SP208E 4 4 24 for clean reception of slow moving signals. SP211E 4 5 28 Ordering Information - page 20 SP213E 4 5 28 Typical Application +5V INPUT 9 0.1F 0.1F0.1F 10 6.3V 6.3V6.3V C1+ VCC 11 0.1F V+ 6.3V 12 C1 15 13 V- C2+ 0.1F 0.1F SP208E 16V 16V 14 C2 400k400k 5 22 TT IN IN RT TT OUT OUT 11 11 11 400k 18 1 T IN T T OUT 2 2 2 400k 19 24 T IN T T OUT 3 3 3 400k 21 20 T IN T T OUT 4 4 4 67 R OUT R R IN 1 1 1 5k 43 R OUT R2 R IN 2 2 5k 22 23 R OUT R R IN 3 3 3 5k 17 16 R OUT R R IN* 4 4 4 5k 8 GND Figure 1: SP208E Typical Application www.maxlinear.com Rev 2.0.0 TTL/CMOS OUTPUTS TTL/CMOS INPUTS RS-232 INPUTS RS-232 OUTPUTSSP208E / SP211E / SP213E Low Power, High ESD +5V RS-232 Transceivers Data Sheet Revision History Revision History Document No. Release Date Change Description - 01/27/06 Legacy Sipex Datasheet. 1.0.0 07/23/09 Convert to Exar format, update ordering information and change rev to 1.0.0 1.0.1 10/15/12 Change ESD ratings to IEC61000-4-2, remove typical 230kbps data rate reference and update ordering information. 1.0.2 05/15/19 Update to MaxLinear format. Update ordering information. Removed obsolete SP207E. Added ESD rating section after absolute maximums. 2.0.0 10/21/20 Update SP211E and SP213E output voltage swing, RS-232 input voltage range, I , CC maximum storage temperature and absolute maximum R voltage. Update Transmitter / IN Drivers and High Efficient Charge Pumps sections in the Description. Update Transmitter Output graphs for SP211E and SP213E. Update Ordering Information. Changes made in accordance to PCN 20014 (SP211E) and PCN 20015 (SP213E). 10/21/20 Rev 2.0.0 ii