180~240W Constant Voltage + Constant Current LED Driver ELG-240 series 8 IP65 IP67 + 0 5 % & 6= B , < % A) /* 678 , 67/ = C D E . - E < E + % F/)))) / % & () ()*+ , & () -)).)/0+ % % (0 /(0 1 2.3 % ()452) 678, 67/ % & () 9 % > 1C % % .GC. % = : (,.7,( ,( ,/(0 : % < 6 = B 1 678 0 > < 1 A 67/ 0 D < 1 678 . - )4-)0 -)0 6* < 1 + 678 + < 1 Dx 678 < 9 9 678 < < 1 File Name:ELG-240-SPEC 2016-11-29180~240W Constant Voltage + Constant Current LED Driver ELG-240 series SPECIFICATION MODEL ELG-240-24 ELG-240-36 ELG-240-42 ELG-240-48 ELG-240-54 DC VOLTAGE 24V 36V 42V 48V 54V CONSTANT CURRENT REGION Note.2 12 ~ 24V 18 ~ 36V 21 ~ 42V 24 ~ 48V 27 ~ 54V RATED CURRENT 10A 6.66A 5.71A 5.0A 4.45A 200VAC ~ 305VAC 240W 239.76W 239.82W 240W 240.3W RATED POWER 100VAC ~ 180VAC 180.36W 180W 180W 179.76W 180W 200mVp-p 250mVp-p 250mVp-p 350mVp-p RIPPLE & NOISE (max.) Note.3 250mVp-p Adjustable for A-Type only (via built-in potentiometer) VOLTAGE ADJ. RANGE 33.5 ~ 38.5V 50 ~ 57V 22.4 ~ 25.6V 39 ~ 45V 44.8 ~ 51.2V OUTPUT Adjustable for A-Type only (via built-in potentiometer) CURRENT ADJ. RANGE 5 ~ 10A 3.33 ~ 6.66A 2.86 ~ 5.71A 2.5 ~ 5A 2.23 ~ 4.45A VOLTAGE TOLERANCE Note.4 2.0% 2.0% 2.0% 2.0% 2.0% 0.5% 0.5% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 500ms, 100ms/230VAC, 1000ms, 100ms/115VAC SETUP, RISE TIME Note.6 10ms/ 230VAC 10ms/ 115VAC HOLD UP TIME (Typ.) 100 ~ 305VAC 142 ~ 431VDC VOLTAGE RANGE Note.5 (Please refer toSTATIC CHARACTERISTI section) FREQUENCY RANGE 47 ~ 63Hz PF0.97/115VAC, PF 0.95/230VAC, PF0.92/277VAC full load POWER FACTOR (Please refer toPOWER FACTOR (PF) CHARACTERISTI section) THD< 20%( load50%/115VC,230VAC load 75%/277VAC) TOTAL HARMONIC DISTORTION (Please refer to TOTAL HARMONIC DISTORTION(THD) section) INPUT EFFICIENCY (Typ.) 92% 92% 92.5% 93% 93% AC CURRENT 2.2A / 115VAC 1.5A / 230VAC 1.2A/277VAC INRUSH CURRENT(Typ.) COLD START 60A(twidth=510 s measured at 50% Ipeak) at 230VAC Per NEMA 410 MAX. No. of PSUs on 16A 4 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC CIRCUIT BREAKER LEAKAGE CURRENT <0.75mA / 277VAC No load power consumption <0.5W for Blank / A / Dx / D-Type NO LOAD / STANDBY POWER CONSUMPTION Note.7 Standby power consumption <0.5W for B / DA-Type 95 ~ 108% OVER CURRENT Constant current limiting, recovers automatically after fault condition is removed SHORT CIRCUIT Hiccup mode, recovers automatically after fault condition is removed PROTECTION 27 ~ 34V 42 ~ 49V 47 ~ 54V 54 ~ 63V 60 ~ 67V OVER VOLTAGE Shut down output voltage, re-power on to recover OVER TEMPERATURE Shut down output voltage, re-power on to recover WORKING TEMP. Tcase=-40 ~ +90 (Please refer to OUTPUT LOAD vs TEMPERATURE section) MAX. CASE TEMP. Tcase=+90 20 ~ 95% RH non-condensing WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +90, 10 ~ 95% RH TEMP. COEFFICIENT 0.03%/ (0 ~ 60) VIBRATION 10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes UL8750(typeHL), CSA C22.2 No. 250.13-12 ENEC EN61347-1, EN61347-2-13 independent, EN62384 SAFETY STANDARDS GB19510.14,GB19510.1 IP65 or IP67 approved DALI STANDARDS Compliance to IEC62386-101, 102, 207 for DA-Type only WITHSTAND VOLTAGE I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25/ 70% RH EMC EMC EMISSION Compliance to EN55015,EN61000-3-2 Class C ( load50%) EN61000-3-3 GB17625.1,GB17743 Compliance to EN61000-4-2,3,4,5,6,8,11 EN61547, light industry level (surge immunity Line-Earth 6KV, Line-Line 4KV) EMC IMMUNITY MTBF 826.7K hrs min. Telcordia SR-332 (Bellcore) 200.8Khrs min. MIL-HDBK-217F (25) OTHERS DIMENSION 244*71*37.5mm (L*W*H) 1.22Kg 12pcs / 15.2Kg / 0.72CUFT PACKING - + BH .)0+ / NOTE 6 I : 0 B& H < H= H J I . : K ) % - I % % % ) - K(8 ( C / % 6 < + +:+ : < 7 HB,H== 8 B , % .)0+ % % 9 < % 9 9 2 > F/) ))) % 6 8) -) 6 % +B * L % C,,%%% % File Name:ELG-240-SPEC 2016-11-29