120W Single Output Power Supply or Battery Charger
PA/ PB-120 se rie s
Features :
AC input range selected by switch
Built-in passive PFC function compliance to EN61000-3-2
With AC ON-OFF switch
3 poles AC inlet with fuse holder
Protections: Short circuit / Overload / Over voltage / Over temperature
Charger type can be selected (Optional)
Charger for lead-acid batteries
2 color LED loading indicator
Open frame models available (Without safety approval)
Low cost, High reliability
2 years warranty
P A 120 P 13 C
S:Power Supply
A:Voltage detector :O.D.M. number
B:Current detector
P:Open P.C.B.
C:With case
P:With PFC
N:None PFC 13:13.8V
27:27.6V
54:55.2V
SPECIFICATION
MODEL PA/PB-120 -13 PA/PB-120 -27 PA/PB-120 -54
DC VOLTAGE 13.8V 27.6V 55.2V
RATED CURRENT 7.2A 4.3A 2.2A
CURRENT RANGE 0 ~ 7.2A 0 ~ 4.3A 0 ~ 2.2A
OUTPUT
RATED POWER 99.36W 118.68W 121.44W
PA series voltage 105% 1% : RED / 105% 1% :GREEN
LED INDICATED
PB series load 46% 10% : GREEN / 46% 10% :RED
VOLTAGE RANGE 88 ~ 132VAC / 176 ~ 264VAC selected by switch 248 ~ 370VDC
FREQUENCY RANGE 47 ~ 63Hz
POWER FACTOR (Typ.) >0.65 (with PFC series)
INPUT EFFICIENCY (Typ.) 73% 79% 79%
AC CURRENT (Typ.) 3A/115VAC 1.5A/230VAC
INRUSH CURRENT (Typ.) COLD START 25A/115VAC 50A/230VAC
LEAKAGE CURRENT <1.5mA / 240VAC
90 ~ 110% rated output power
OVERLOAD
Protection type : Constant current limiting, recovers automatically after fault condition is removed
15 ~ 17V 30 ~ 35V 60 ~ 66V
PROTECTION OVER VOLTAGE
Protection type : Hiccup mode, recovers automatically after fault condition is removed
RTH270 10 detect on RTH2 thermistor
OVER TEMPERATURE
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
-10 ~ +45 (Refer toDerating Curv)
WORKING TEMP.
20 ~ 90% RH non-condensing
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY -20 ~ +85 , 10 ~ 95% RH
TEMP. COEFFICIENT 0.05%/ (0 ~ 45 )
VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY STANDARDS UL60950-1, TUV EN60950-1, EN60335, EN60335-1, EN60335-2-29 approved
WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
SAFETY &
ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
EMC
(Note 4)
EMC EMISSION Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3
EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
MTBF 149.6K hrs min. MIL-HDBK-217F (25 )
PCB Type:144*90*33mm External case type:180*96*49mm (L*W*H)
OTHERS DIMENSION
1.1Kg; 16pcs / 17.9Kg / 1.47CUFT(without PFC) 1.24Kg; 16pcs / 20.1Kg / 1.47CUFT(with PFC)
PACKING
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
NOTE
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
5. With PFC I/P range: 95~132VAC/190~264VAC.
6. For open P.C.B. WITH 17.8CFM min. Forced air.
File Name:PA,PB-120-SPEC 2015-03-12120W Single Output Power Supply or Battery Charger
PA/ PB-120 se rie s
Mechanical Specification
Case No. PS-120A Unit:mm
3 pin XLR
1 2
3
CASE:
Output cable length=183cm 5cm
Pin No. Assignment
1 DC OUTPUT +V
2,3 DC OUTPUT -V
PCB:
AC Input Connector (CN1) : JST B3P-VH or equivalent
Pin No. Assignment Mating Housing Terminal
1 AC/L 180
JST VHR JST SVH-21T-P1.1
2 No Pin
or equivalent or equivalent
144
3 AC/N
134
5
DC Output Connector (CN3) : JST B4P-VH or equivalent
Pin No. Assignment Mating Housing Terminal
CN3
1,2 -V
JST VHR JST SVH-21T-P1.1
or equivalent or equivalent
3,4 +V
12VDC FAN Output Connector (CN4) : JST B2B-XH or equivalent
ADJ.
Pin No. Assignment Mating Housing Terminal
CN4
LED
1 +V
JST XHP JST SXH-001T-P0.6
1 2
or equivalent or equivalent
2 -V
+ -
CN5
1 2 3
SHORT FOR 115V
CN1
OPEN FOR 230V
115/230V selected by switch Connector (CN5) : JST B2P-VH or equivalent
Switch Assignment Mating Housing Terminal
115V Short
JST VHR JST SVH-21T-P1.1
or equivalent or equivalent
230V Open
Derating Curve Charging Curve
Vout Iout
Bat. Voltage
105%
100%
100
Charging Current
Open frame series
100%
17.8CFM air cooling
80
(L=15cm face HS)
45%
Other series
T
Red Green
60 LED COLOR
Type A:Voltage detecter,pulse charger
40
Vout Iout
Bat. Voltage
105%
100%
20
Charging Current
100%
-10 0 10 20 30 40 50 60 (HORIZONTAL)
T
AMBIENT TEMPERATURE ()
Red Green
LED COLOR
Type B:Current detecter,2 voltage section
File Name:PA,PB-120-SPEC 2015-03-12